Update:
I want to thank everyone for your comments up this point.
Yesterday I was removing some of the terminals from the LBCD, starting with the top one. I put it all back together and, as you know, nothings would start.
Today, I was able to pull the LBCD, which was a total pain to explore it more. While doing so (with the power on), I was removing the top terminal and I could hear the all the buzzers in the interior turn on!
View attachment 871082
From the prior day, I inadvertently sheared the stud on the 24V Batt terminal. This was an oversight on my part - I think this is a special stud. Notice the threads taper to a smaller diameter?
View attachment 871081
The other issue is that the nut that was epoxied into LBCD was loose and can be removed.
View attachment 871083
Here is a picture of the little bit of the stud still inside the LBCD.
View attachment 871084
So, I need some recommendations.
1. Do I attempt a repair or do I need to replace?
2. If repair, how to secure the nut into the LBCD? Epoxy, some other adhesive?
3. Do I attempt to remove the bit of stud?
4. If yes, any ideas on where I can buy a replacement?
5. If no, do you suggest a conductive paste or another solution?
6. Did I forget to ask anything?
Thanks in advance guys. You have been very helpful!
By the way, I checked all the battery voltages today. All stable at 12.4V- 12.8V
