Iambiig
Member
- 68
- 22
- 8
- Location
- Jackson, New Jersey
Is there supposed to be a grease fitting on the rear lowers? Found the uppers, but not lowers.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
M998 LOWER REAR BALL JOINTS LUBE
- Thread starter Iambiig
- Start date
rcamacho
Well-known member
- 764
- 813
- 93
- Location
- Bainbridge Island Wa
Nope.
Highly recommend checking for wear per TM.
Sent from my iPhone using Tapatalk
Highly recommend checking for wear per TM.
Sent from my iPhone using Tapatalk
Iambiig
Member
- 68
- 22
- 8
- Location
- Jackson, New Jersey
Thanks. Boot looks fine, I was just trying to put some fresh grease in there
- 279
- 391
- 63
- Location
- Cleveland,TN
IF I'M WRONG someone will chime in for sure, BUT all the ball joints have a grease fitting. I would look again if I was you! I think someone didn't screw the zerk in or it "fell out". My trucks all have zerks on ALL the ball joints.
- 2,832
- 4,038
- 113
- Location
- Olympia/WA
I just greased everything, including the lower ball joints, in my M1123.
Can't vouch for older trucks though.
Can't vouch for older trucks though.
- 1,402
- 582
- 113
- Location
- Quantico VA
I have a 1987 and some of the ball joints have zerks and some do not. So far I haven't had any problems. At some point in the future I will replace them all, but not today and tomorrow's not looking good either.
BDGR
BDGR