Search results

I'm in

Sorry, I thought, by putting Deuce in the title, I thought the truck type would be obvious, and posting on the Deuce Forum would leave no doubt. Anyway, it is a M35A2. I have seen the picture and read the 4 step procedure in the -10 manual, but it to me does not seem so clear. When you put...

I bought a winch, and it came without the cable. I have looked and looked and cannot find any information on how the cable actually attaches to the winch. I have a clevis for the business end, but do not know what the other end is supposed to be like and how it attaches. Any help in this...

Not that knowof, according to the manual it is straight thru the same size.

I don't understand, can you be more specific? Thanks clay

I replaced the spindle bushing on my deuce and cannot find any info on what the clearance should be between the axle and the bushing, and or if it requires reaming. The manual just says if it is bad, replace the spindle. Since there are replacement bushing, there must be a procedure to do...

Do you have a cable for a deuce front winch, if so what would you ask for it? Thanks Clay

I really appreciate the repost, I am a late comer adding a winch to a non-winch truck.

I just happened to acquire the triangle pieces with the extensions and the supports. I was traveling back from Connecticut to Florida and made a detour to White Owl. They cut off the bumper ends, and the frame behind the extension and I got the whole framework. this is good to know, I don't...

Yes all but one, it is snapped off in the side of the winch. Right now I don't know which one it is, but I will find out this weekend.

I am trying to find information on the long bolts that connect the bumper to the frame extensions, and the Winch support long bolts. the ones I am looking for are the bolts that run thru the frame structure, the front ones are about a foot long and the shorter long ones are about 6" long. Any...

In

Thanks so much. I was going nuts trying to figure it out. I am not crazy after all.

Vote for #3 awesome truck and scenery.

I have looked at all of the pictures of the Air Pack(AP) parts, and I don't see what I have left over after a rebuild. I know I know there shouldn't be any left over parts, but either I don't have the updates to the rebuild manual, or the part does not belong to the AP. I believe it goes in...

I think 99nouns has it, these steel soldiers can go anywhere and will run over anything.

So does the bearing have to be seated on the shaft all the way to the spline section for 1st gear? I see about an 1/8" between the bearing race and the bottom at the spline section.

I am sorry for not knowing if this exist, but I looked and don't see it. I am rebuilding a deuce tranny, and when I put the main shaft back in, 2nd gear comes in contact with the reverse idler PTO gear. I don't know if this will work it self out when the rest of the parts for the rear of the...