Search results

Testing as per 5(d) with 24 volts, none of the 3 relays test good or click. I don't show a K1 relay though. I think maybe my k1 is marked k7 on

Tha Thanks, I should have time tomorrow.

I'd be up for testing everything myself if you can tell me how. I dis and reconnected the power by disconnecting the batteries.

Ok, so R3 on the A5 card looks like it might be burnt , not as bad as in your photo but I can seen either light burning on the back of the card or the shadow of the resistor I think its called. My special relay box was missing the cover plate and 2 of the relays had the screws missing but...

Thank you again for your time. Enjoy those kids.

I couldn't find a cb1 to push in. S1 in start position a4-2 and a4-8 neither have 24 volts. Also tried with battle short switch on and dc breaker pushed in.

So a4 card looks good. No burn spots and solder on back look perfect. It does have 2 relays plugged into it and all the wires are hooked up just like in the attachment. Thank you for your time.

The batteries are fully charged. Placing a paperclip in a and b and the unit still doesn't try to turn over

,,

With the switch on, the under volt, under freq and low oil pressure lights come on. With battle short switch on the battle short light comes on. Engine prime switch on but no ticking or anything else from the fuel pump. I don't see a tm for the 105a generator set, am I just not finding it? Can...

I do have 2 mep 105a generator sets. 1 of the sets looks like it was never run. Clean empty tank, no oily dust anywhere, no cracked paint etc, but the electrical panels were unplugged and removed. The set that I am working on has 1800 hrs on it, allis chalmers looks great , clean oil...

I have a mep 105a (2 actually) that I am trying to get working so I can run some 3phase equipment. Batteries hooked up for 24volts, I've got power to the starter switch and battle switch, and all the test lights work on the panel. I get power across the switch when pressed from run to start but...