Search results

- 3116 Engine year ...1997 - Engine serial number ...7AG04596 - approx. position of the union on the block ...mine looks like the pic you attached, not straight...but it is bone dry, for now... - has yours broke ...NO - is yours leaky presently...NO - I will replase the oil line with a new...

Hello all. Today I was sniffing around under the truck for some mantainance and notice that of 4 screws that hold the starter and attach it to the flybar, 1 was lost and another one was on the way of loosing... So next time when you are under your truck throw an eye on it... Christian

Hello! I immagine you use a flexible tube instead of a rigid one... Can you please tell me what type of tube you use? Pressure is not really a problem I think, but temperature? Thanks a lot!

rofl

Maybe you can put a electric motor of a electric car on it. The first hybrid LMTV :-) Christian

Yes will do when I have more pictures and work done... :-) For now I only mounted the throttle switch and do all the electric wiring inside. Need to change vertical exhaust tube from turbo to muffler with a stainless one. Maye there are also mild steel v-band flanges, but I didn't found...

Preparing to install an exhaust brake on a M1078 A0, the throttle switch...

Nice!

Thanks! But how to know what part is what? There is no description, just a s.n.... :-)

Very nice! Christian

Used as our second home... Öland, Sweden this summer Christian

Hello all. Does anyone know the right transmission oil level with cold oil and stopped engine on a M078? I change from normal oil to ATF and now I have the problem that the level is not clear enough for reading with running engine. Right now it's about 1 inch below min. with stopped engine...

Hello all. As promised the Arduino sketch for the CTIS controller. The sketch is complete, but the I/O pin's are set on default. This because depends on the wiring (I made a PCB). The sketch is also able to read / write the default pressures of the 4 terrain modes. You need to write the 4...

If you are changing the tire and the CTIS wheel walve will not close after pressure check or inflating, check the banjo screw if there is some dirt. Happen to me yesterday. If the pressure don't fall under 20 psi between wheel valve and banjo screw the membrane do not close... Christian

Hello all! I have a strange problem with the air brake pressure gauges. Pressure is about 120psi on all 3 tanks, CTIS is working well, but the 2 pressure gauges shows front brake 90 psi, and rear brake 120 psi. Does anyone had a same situation? The 2 pressure transducer are near the left front...

Any news for the lockers? Christian

Mine also, registered in Germany. Italy is a nightmare, but I will retry this winter. Christian

Hello! I now build in total 4 and sold 3. If someone need a complete ECU as descibed before I will sell them for 200$ + shipment. Christian

Hello all. Sorry for the late answer, but due heavy work I did not found the time to answer. After 2000 miles I must admit that the Arduino and CTIS do a great job. It works like a sharm, every 15 minutes checks the pressure and adjust it. No problems after all. More problems with broken...

If you don't hear any solenoid clicking means that the system is not ready. Most probably as Ronmar wrote the wet air tank sensor...