• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. Suprman

    Need help with Allison Pan Removal

    I have a pan casing if you can swap over your solenoids. Which you usually can. Will
  2. Suprman

    Driving Denver to Orlando, Starting 20May2021

    What inspired your move? I have a big property in alabama. Been working towards building a house there.
  3. Suprman

    Brakes "bucking" after stopped

    Are you sure its not driveline related? Sometimes the throttle assembly on first gen trucks takes a bit more time to come back to rest position. I usually have to add better springs to the throttle return.
  4. Suprman

    Truck won’t start and transmission pad not lighting up

    I would start by adding a large ground wire from the batts negative to the main frame rail. Then check the connections on the polarity box its under the spare tire.
  5. Suprman

    Truck won’t start and transmission pad not lighting up

    Take it out and open it up. A wet wtec3 keypad can put the truck into drive on its own. I would replace it. There’s nothing special about the keypad its the same civilian wtec3 type.
  6. Suprman

    Truck won’t start and transmission pad not lighting up

    You can also jump the large relay on the inside of the drivers frame rail to crank. Your issue sounds like a keypad or tcm issue. You can take the keypad out and open it up see if its wet.
  7. Suprman

    M1084 crane hydraulic troubleshooting

    There is a lockout solenoid for each function. The crane movement like that controlled by the box on the side of the crane with the cable coming out of it going across the boom. Its called load moment.
  8. Suprman

    M1084 crane hydraulic troubleshooting

    On the hyd manifold. There are control solenoids on the valves themselves and lockouts on the manifold body. There is a main feed behind the manifold with a lockout on it too. Did you try putting the outriggers down farther?
  9. Suprman

    M1084 crane hydraulic troubleshooting

    Yes. The outrigger down sensors werent working so the upper bank was in protection. You can unplug the lockout solenoids and the crane should work.
  10. Suprman

    Truck won’t start and transmission pad not lighting up

    The pdp is the circuit board breaker relay panel on 3126 trucks. Feel it see if sockets are loose in the board. Visually inspect. A bad board usually causes odd intermittent issues. The wtec3 tcm is a common failure. Keypads go bad too water drips down onto them over time and gets in.
  11. Suprman

    Truck won’t start and transmission pad not lighting up

    CT. A used replacement is 550 shipped
  12. Suprman

    Truck won’t start and transmission pad not lighting up

    You can send to me to test it if you want. Wtec3 tcms are easy to kill when jump starting the truck unfortunately
  13. Suprman

    Truck won’t start and transmission pad not lighting up

    Where are you located?
  14. Suprman

    Truck won’t start and transmission pad not lighting up

    Sounds like a bad trans tcm its under the dash behind the passenger side kick panel. I have replacements. You can also check the circuit board power panel. Some used low lead solder and can develop bad solder joints.
  15. Suprman

    M1088A1 Spaghetti Monster

    I believe it goes over to the hand brake valve to the right of the steer wheel. I have put that mess back together before. Its doable just take it slow.
  16. Suprman

    M1088A1 Spaghetti Monster

    The big ground strip mounts on the back side of the pdp metal frame.
  17. Suprman

    WTEC II help-- hesitant downshifting

    Some older cat motors need the injector/rack adjusted. They are just sluggish. Sometimes your throttle cable is out of adjustment and you are not getting full throttle.
  18. Suprman

    Gen trailer southhampton NJ pull out

    Ok thank you. I may have found someone to get it during their pickup hours I will let you know Will
  19. Suprman

    Source for LMTV CBs and relays.

    I have the relays
  20. Suprman

    Gen trailer southhampton NJ pull out

    I have a drash trailer its at a lumber yard in southhampton nj. They only load out wed and thurs from 9-1. I was wondering if I could pay someone in the area to pull it out for me and I could have it picked up at their place. Thanks Will
110,879members
165,308threads
2,326,153posts
1,357online users
Top
✖
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks