Search results

Im in the heat all year so i disconnected the high idle solenoid and pulled back the shaft. I adjusted the throttle screw but no change. Its just an ⅛ of a pull to get her into the correct idle. Im gonna try another spring if not search for another throttle cable.

Howdy. Just installed by freshly rebuilt pump but the she is running a bit high on rpm. I can manually put the finger on the throttle lever and she will go down to the correct idle speed. I ruled out the pump weights since she spring back into position. I oiled my throttle cable and the...

Howdy. Just noticed my vacuum lines and they are flat as if the negative pressure is collapsing them. Could it be a bad pump or bad hoses. Those hoses were there when I got my m1008 but im gonna swap them just in case. Any suggestions on what hoses to use?

Looking for the actual bottle if anyome has any to sell.

My Humvee and M1008 identify as a Teslas for legal reasons. 😎

Whats the carbon footprint on them horses. Likely to get cancelled along with the cows. 🤣

Here in PR the local consumer protection agency regulates the profit margin on fuel and has stations posting fuel delivery dates. This causes up and down pricing based on when the gas station got its fuel in relation to market prices. Its an anti gouging measure.

Get with the times. Its a new model called Brandon economics.

Check the magnetic pickup under the starter. Voltage should be from 2.3vac to 3vac. The tip is either ground off or full of metal scrapes. Sometimes its just a bad terminal. I use a broom stick to turn over the dead crank while looking at the voltmeter and slowly turning the mag pickup. Review...

Howdy folks. This is just a joke since I saw one of those old electric car turbo ads and got some inspiration. I must report that there were no noticeable performance improvements. Hope you all enjoy your memorial day weekend. 🍻

You can also use your car as a backup house "generator" in case of an outtage. Screw that, i will stick to my diesel genny that gives me power and can charge any future EV i might reluctantly buy.

Lets go Brandon!

They really did you in with the hole so low. I got one with a drill hole once but was high enough for this type of plug. https://www.amazon.com/Dorman-65240-AutoGrade-Drain-Plug/dp/B000COBBSO/ref=sr_1_1?keywords=65240&qid=1653670500&sr=8-1

Yes, no parts were replaced. Contact cleaner and the excersizing of the switches did the trick.

Im looking for that tool. You selling?

OK, after loadbanking her for a while, she would not trip easily. I could take her to 16kw and after a few mins she would drop the load but no overload light would come on. So its probably a bad fault panel. Im gonna leave it as is since it does it job of dropping the load just not turning on...

Gonna load bank her today. Could not go to the shop in the last couple of days.

And with care. These switches have a plastic shaft that yoy can easily shear off if they are stuck.

The fault monitor has displayed the fuel and temp errors. Im gonna overload it today and see if it trips.

Is the tour done on a gurney. Asking for a friend. 🤣