Search results

Has anybody removed the bed off a machine shop truck? Need advice on doing this.

Has anybody else had a problem with the rear shock axle mounts? The lift has rolled the rear axle up in the front enough that the passenger side shock won't mount.

Got to build a 1028 with 6" Skyjacker lift, 37" humvee 12 bolt wheels and tires, front & rear 2" receivers for winch and trailer use.

Best mounting points I have ever seen were along the outside of the frame, under the bed from the rear, with a hole drilled in the foot of the spade and a wing nut used to hold it to the body of the truck.

Diesel doesn't need stabilization like gas but might want to add algaecide. I am adding the extra tank to my USMC 1028, already have the dual tank bed on the truck. But I think I will use the 5 ton dual tank valve and just let the stock switch change which tank the gauge is reading.

What is the scrambled mess of links in the lefthand corner of the picture?

Can we know from were? I need to change the windshields in my guntruck.

Sounds like you cut up a set of axles from 102" trailer to fit 96" trailer? You could always just use a set of the M35 to 5 ton adapters, but I would like to just change hubs also if a 10 bolt set will swap. simp5782 knows more about swapping hubs around than I ever will, might get him to chime...

Okay so I would drain all the coolant and remove the lower radiator hose and look athe the inside of the radiator there to check how clogged the radiator is. I have seen many of these trucks that looked good from the top that had several inches of mud like buildup in the bottom of the radiator.

I would say that the outrigger out and dangling but only about a foot away from the bed of the truck would be all that is needed. That's what I was told to do but never have. Only rear cable I have ever broken was on 816 that I was overloading, pretty sure all of the 936's will bypas before...

Unless you need the truck back up and running ASAP I would go ahead and do full rebuild. It is so easy if you have it down that far to at least check out all the bores and if anything is wrong change it. Also to clean out everything fill with gasoline and then diesel it should come out very...

I have a few trucks with DWFK (Deep Water Fording Kits) on them. If you would like to come over and take pictures and make notes about the kit come on over. When and if I can get a chance to I will be doing a write up on here.

Yeah one or two.

Yes I believe it is 8" difference.

Not much help but believe the spindle is the same as the M105

In

Okay so as to the check valves I am 90 percent that they are there but as you said for a catastrophic failure not the easy down of the control valve, yes they are supposed to come down when the truck isn't running and you push the lever. It is not a power down system. Pretty sure if you get a...

Welcome to the green sickness unlike the COVID-19 there is no getting out or over the green fever and now you have a wrecker welcome to buying everything you can get to outfit it! By the way you have a very special wrecker I believe that may be a test mule for the military and or BMY ? Please be...

No thread just know he has one! Pretty sure any two button remote will work then just add a pair of electric solenoids to the hydraulic lines and bobs your Uncle! Sent from my SM-G930V using Tapatalk