Search results

Does the picture you include have a body lift?

Yes, torque. I read somewhere that the TPI had long intake runners that made alot of torque at low rpm. Article said it would have been the perfect truck engine with broad torque range. Anyway, not sure how it compares to stock LS. I think I've changed my mind regardless of fit. Any change will...

I've had a Duramax in a 2500 Chevrolet. Built it up till I blew the head gaskets and spun the Allison transmission in it. I built it all back and it was a tough, super fast truck but a Duramax Allison combo puts me in a repair category I would not like to be in. Given my abilities and local...

Another question I ask myself is should I put a LS in even if it cost a few more thousand dollars.

Have a complete TPI engine local to me available. Will the intake fit without cutting under windshield?

Installed the new alternator bracket

Alternator kit had a pulley also. Might use it to have correct belt groove.

Update on the alternator conversion. I started modifying the factory aluminum 60 amp bracket. As mentioned earlier when modifying I had to drill and tap a mounting point for the pivoting side of the alternator. I drilled the hole close but not in the correct location. I could not find a 60 amp...

Found 2 gentleman who are active service in Chattanooga. They came on time worked diligently and finished the job. They were a pleasant change from the usual caliber of people I encounter.

Thank you!

https://splawnbelting.com/technical/v-guide-groove-dimensions/ The hmmwv groove size.

Mogman, Do you know the correct profile for hmmwv?

Yes I ground down the bracket. The idea worked perfectly my execution was another story. You have to grind both sides. I didn't grind the face of the bracket far enough to get proper belt alignment. It could be removed and corrected with more grinding. I had to drill one mounting hole for pivot...

Here's how I did mine last year. I didn't get the holes drilled properly and had wrong offset. I ran it anyway. The alternator started overcharging. I have a replacement Delco and original generator. I'm going to buy another alternator bracket and get it correct the 2nd time.

Does anyone know of a good shop or individual in the Chattanooga, TN area? I need a water pump replaced on my 6.2. I've done alot myself but want some help with this one. Wish I would have proactively installed one when I swapped radiators about 6 months ago. My cell is If this is in the...

My memory is foggy on that. Jack your truck from front and back to your desired ride height. Measure the distance between perches. The springs are around 500lbs per inch of compression. If you can weigh your front and rear(some truck stops have scales). You can do the math from there. They are...

I ordered 4 springs all the same. I cut one coil from rear. Can't remember what I did on front. I do know i tried to put rears in without cutting. It raised the back off ground when trying to jack a arm up. I since have added a spare ture carrier and the rear sits a little lower than front. I...

I installed the cepek adjustable shocks. To recap, m998, soft top and doors, armada springs, run flats removed, cepek adjustibme set on 2(very soft), sway bar attached, spare tire carrier. The truck rides great, takes speed bumps and bumps fantastic. Offroad is much more pleasant with better...

The wheels looked true when on the balancer. Feliz tires seem to be very reasonably priced...

I have Trail Worthy Fab beadlock inserts on 12 bolts with Goodyear MT OZ, centramatics, and the tires balanced also. The tires are not round and it shows at speed (70mph I have 4 speed). Do the Baja run true? I like the wheels and the inserts so looking for best 16.5 option. I know super swamper...