Search results

With some engines running hotter and higher pressure I try to change belt and hoses at 4 years

My last trip to the DMV They relied on there computer I tried to get multi fuel on the title because it was a multi fuel I had to pick gas or diesel that what was in the computer. I tried to get Kaiser Jeep on the title I had to pick Kaiser or Jeep (Kaiser Jeep ) is not in the computer . I...

I like scrubbing with a stiff brush and hot soapy water hose it off and spray on paint or brush it on new paint . pressure wash works great you can clean out small places that you can't get to any other way . Bolts I have taken them out bead blasted them and painted them and put them back in( it...

I have used a box end open end wrench cut in half because I needed to use a cheater pipe on it a socket will come in handy to . The threads are all the same right on left off the nut size is 2 1/4 on older trailers some are 2 3/8 .

I have pulled a third member out of my M211 when I found metal to discover it was trash from a past over haul . good luck and let us know what you find .

The only place my 43 White says White is the brake and clutch peddles .

Look at Memphis Equipment site for m35 and it should be listed just needs cut down . when I ordered it was each strip by it's self It is nice stuff not like the rock hard stripping I chipped off .

I think the weather stripping around the door glass and the top are the same as the m35 or 5 ton .

What speed and RPM is your truck is running best at ?

Legally brakes are required . You might check used equipment places and find a commercial dolly .

Because of the size and weight of your truck and trailer it may not be commercial but weight wise its heavy enough to be .It's about safety .

The dolly would not need lights when hooked up to the trailer or mud flaps if pulled with out the trailer it needs both .working brakes on the dolly are a must have .

Has any one looked at the end of a crank on a 302 to see if it has a hole for a pilot bushing ? I bought a CCKW that has the 270 engine transmission and transfer case still in it that I don't need if any one is thinking of trying to swap over or have questions .

Sam Winer Motors ( 330-628-4881) I bought from them when rebuilding my m-269 also made in 1954 by Pressed steel Car Company . The hubs heaver then a regular 5 ton be careful when removing . I replaced the brake pods with new type 30 . At the time I thought the taller spring brake pods may hit...

The information I posted was from Technical manual 9-8024 page 70 .The least I would do is pull one front axle drive flange and one axle from each rear axles .

The Radiator in your m51a2 sits close to the hood you may be able to move it up about an inch or so be for it hits the hood . The lower the fan the better there may not be much space between your valve cover and the hood at the front of your new engine. I don't know how tall your 466 is fan...

Made these to stand on when working on my M52A2 there is a lot of good space to make storage .

I use the black rubber ones at work they have the hollow spaces on the bottom . on soft or muddy ground they push in if the truck rolls on them they work better on there side . on hard ground if the truck is driven over them they split and flatten out .

When using gin poles a load left hanging will also untwist your cable .

PM sent