Search results

You need : 2 ea. 12480843, and 12480841, and 12480840

Speedo cable sometimes hangs up, and zip ties will stiffen wires up alittle...I'd cut off zip ties.

No.

If you figure out which wheels you need..I might have them.

same basic frame...If kit comes with the bezels....you will probably have to redrill window frame and use self taping screws for bezels.

Montana : OH, On Highway, or Over Highway.

cross over is : 12554091....I might have one.

Wires up by wiper motor are heated window control box wires...Not needed.

The relay behind the front right seat will sometimes be stuck on with ignition off. If stuck on...it powers the trans computer.

Over a year for me also.

There's a third check valve on 90's and up trucks on fuel filter housing....its a weak one and should be fine leaving it.

Dec 17, 97

If the plates are original...doors have a 2 layer plate...outside is hard steel, and inside plate is soft steel.....just drill out rivets...remove plates...install some rivets in holes.

I have some...but only one side...I'll see if its the one.

The yellow and black tach drives work the same on the 4 screw buss bar tachs...as I tested a bunch with a drill and 24 vdc. I noticed that most of the black drives were on later 6.5NA GEP motors.

M1165 trucks did not have turrets...plate is factory. You can install one with that black adapter ring. The gear ring you have is not for that system...Its for a M1114. An M1114 bearing can work with that black ring by drilling 12 holes. I've had all types of these systems for years....before...

There are 2 different 4L80E trans...early and late...different bolt patterns....your pic is the late one.

I have some if needed.

.

Papers.