Search results

When I put the transfer case PTO on my m52a2 I took the oil line off of a m816 wrecker it had the two check valves one in the bottom elbow and the one where it go's in to the PTO .The PTO oil pump , pumps in both direction .I think the check valves work together to keep oil going the right...

I set the Mack ENDT 673 in my truck today to see what I need to change . The frame needs to be trimmed I not sure how much to trim off may be a Mack owner could Please post some pictures ?

This trailer is for a 5 ton I did pull it home from the scrap yard with my m211 tractor that is loaded on it in the picture it weighs 15000 and that is about the limit that the GMC trucks could pull . you might search m275 tractor with trailer there should be some pictures .

1954 m269 Wrecker low boy

I bought my M211 in 1984 and the owner had 4 small marker lights on the bed with the small push in bulbs and hooked them up to one battery (12volts) I only used them at night I went through a few batteries I did not think the lights where the problem them the regulator went out and when I...

Memphis Equipment (901)744-0600 Gear box gasket and seal kit # 8333631 power cylinder parts kit # 8333796

There are some complete engine sets on E bay One set dose not look right and they want $25 for shipping another set the shipping is free . The right sales person should be able to help you don't tell them it's military just 302 GMC

Just maybe the air from the air pack flowed back to the master cylinder and up the vent to the central vent right by the old air filter . this one vent is tied to every thing check your master cylinder to see if air is bleeding in to it ? years back I over filled the gas tank on my GMC...

Pulled the LDSa1 out of the truck today I need to reroute the fuel line air line and replace the brake line on top of the third member .

I could use some pictures of a mack 673 in a truck I have never seen one .I know the top frame rail cut but I'm not sure how much is gone or how long the cut is . also any pictures of the front of the engine in the frame and how much space between the fan and the radiator ? thank you

I was lucky to find used lumber to use on my m269 wrecker lowboy some came from a old bridge it was thicker so I used it on the out side's where the tires of a hauled truck would be the other would I come across I used in the center . I used 1/4 self tapping screws a # 1 drill bit works...

Maybe this helps

I would Check the wheel cylinder for leaks repack bearings new seals if the wear ring is grooved replace it . then back together

I have had gear oil from the rear end leak in to the bearings and have it look like that . I have been using a tan colored wheel bearing grease from Napa . when it leaks in to the bearing it starts washing off the wheel bearing grease . I could be wrong but the bearing looks to clean to be...

The pictures are great . if the brake pad is loose you need to replace the shoes because they will come apart .

My mount looks like it's 5 1/2 I could be wrong it's hard to see looking at it the angle .the bottom bolt looks to be centered at 3/4 inch from bottom of the plate . one of the pictures shows where the spring mounts for the master cylinder .and how far the drive line should be from the...

Centered the bell housing and drilled new dowel pin holes .

I think they came on early wreckers I had to get one from Memphis that was rebuilt .

Nice . rear winches are good to have when needed .

What will you power with it ?