Search results

Thank you Rick! I will check it out first thing and let you know.

Good evening, hope all is well where you are. I have been making good progress these last two days reassembling my truck. I have encountered one issue tonight. I have installed new transmission mounts and motor mounts. When I went to install the front drive shaft, the transfer case front...

Thank you!

This may help. lo9-2320-289-12 1 LOGSA

Another good afternoon. Finished up the crossmember and tightened up the cab mounts. Installed the torque converter bolts. Somebody help me out, do the transmission lines go behind the oil pan and then forward on the drivers side of the oil pan to the radiator?

Based on your original post, it sounds to me that without the opposing pull of the passenger side alternator that the water pump shaft is getting pulled toward the drivers side causing the belts to slip. Your original idea of moving the drivers side alternator and wiring to the passenger side...

Today has been a good day. After several months of doing little things at a time resealing the engine, trans and transfer, I have finally started putting the truck back together. Engine and trans went back in today. The transmission dipstick and the vacuum hardline are really fun to put...

A little help for the power steering. If you look at the bottom adjusting bolt on the power steering pump, the bolt takes a 15 mm socket. BUT, on the other side of the bracket is the “nut” that the adjusting bolt threads into. You can put a 15/16 socket on that. Then use a ratchet strap from...

Congrats! Honeymoon at the bivouac site!

You might try to see if your local landfill or recycling company has scales they will let you use. I have done that with my RV at a local recycling place.

Some progress today. The new 90 degree fittings came in today. view from passenger side front View from driver’s side front view from below

Hang in there Rick. We are all here for you.

Here is the reason I cannot go over the top of the crossover. The M1031 has a governor control for the engine throttle. No room to run the hoses.

Getting closer to putting the engine back in the truck. I have installed the PBD cooling upgrade. Being that mine is an M1031 , i ran the hoses along the edge of the drivers side head and had them come out below the thermostat housing. I have ordered 2 each 90 degree elbows so I can connect to...

And, hillbilly wizard has one ready to go. https://www.hillbillywizard.com/cucv-and-k30-parts/steel-fuel-line/

I did some looking in the -34P. Found this, seems you can make item 16 from steel tubing and item 14 if you are handy bending tubing and using a flaring tool.

If you run a separate power line for the led light, you could use the reverse light positive to activate a relay for the led light. Withe relay under the hood or in the cab.

You could tap in to the reverse light on the left or right side or at the connector on the frame.

Let’s try this differently. Are there any members here that have an M1031 with the apecs 4500 controller from b4thunder in Florida or south Georgia? I plan to get the controller and the programming interface. I have read the software documentation, I can copy the calibration file from an already...

Hello All, I have read all of the threads about B4Thunders apecs 4500 controller from years ago. I would like to try this setup. Does anyone have the programming parameters? I can get the controller, the programming interface cables and the software. I just need the specs. Thanks ahead of...