Search results

Please include me in the drawing!

This should be the correct replacement. I wouldn’t run without one installed. Check Valve

This is the set I used. Safety Wire Set

I’ve been looking at pictures on the site of how to safety wire the drums to hubs as it was missing when doing maintenance. I’ve never done this before and for some reason cannot grasp how it’s done in the pics/tm/ps magazine articles. Does the way I’ve done it look even remotely correct? can...

The front axle service is finally complete! Test drive was successfu! Steering response was so much nicer and the front drum temperature after a drive barely hit 100 degrees. New inner axle seals New inner hub seals New spindle nuts and star washers NOS inner axle seal retainers for bendix...

Some old brake lines

A few more pics

I replaced the front brake cylinder and soft line from axle to brake cylinder on the passenger side…. Turned into replacing the distribution block soft line and drivers side hard line. Inspect your soft and hard lines!! The soft line is like a wet noodle! For those of you that knew Frank8003...

Drivers side kingpin shim. … the grease was hardened to a rock like consistency. No way any fresh grease could get past that clog!

I’ll go ahead and install what I have. I saw the specs in the TM the other day and found it in another post on this site. Attached the picture for reference.

Looks like the upper kingpin bushing need to be replaced and a spacer was missing. I pulled a new one from my parts bin, but aI think its missing the inner bushing? The old one has grooves inside and the new one is smooth. The new one fits on the kingpin with almost no play. Can a kingpin...

Inner axle seal retainers finally removed. The correct retainer is missing the inner thrust washer. I ordered 2 correct retainers from White Owl.

Just a few more pics as I await the arrival of my new slide hammer to remove the axle seal retainers. I'm not sure how it was operating normally, but one of the axle seal retainers is for the u-joint style axle shafts.

I’m doing my first front axle service on Deuce 1 and found I have the older style ball and claw axles. Ive learned that they use a different retainer than the newer u-joint axles. I have 2 different retainers installed. One with a flat side facing out and one with a stepped side facing out...

Greetings, I am not sure if this I the correct area to share his, but I found some 2 hole injector nozzles for a great price. $4.25 each, shipping wasn’t too bad for me, added about a dollar per unit for the batch I ordered. https://real4wd.com/product/nozzle/ Hope this helps some of you guys...

Here is what I have.

Give AMBAC International a call 800 628 6894, they sent me some manuals in the past and helped order some small parts for the PSB6A injection pump.

I picked up a second Deuce, a 1971 Kaiser M35A2 WO/W from a member on this site a few months ago and have been slowly making my way through it. So far I have: Replaced the air governor Replaced almost all injection pump fuel lines (1 more to go) Greased all points in the LO (with the exception...

I am working on replacing the copper fuel line on my M35A2 with the original primary fuel filter head mount. If I figured everything correctly here if what I think I will need to replace the primary copper supply line with new rubber fuel hose: In-tank pump outlet to filter - 3/4-18 inverted...

Would it be possible to leave an Airtex in line pump in place without power and have the OEM lift pump running fuel to the primary filter? The Airtex would be left in line as a back up and only energized if needed. What fittings are on your fuel pump mount and the OEM primary filter?