Search results

Here is the kit you are looking for. 57K4882

I couldn't find a hardtop and slantback setup for less than 8k. Plus all the extra parts I can sell or keep in my shop. The two man M1152 has no seat bases or rear seats. That's at least worth $800 in parts. I figured with all the small parts I would need, this was the best route, plus its...

I just finally was able to get a parts unit M1167 with hardtop and slantback. Has anyone converted a M1152 to a slantback? It can't be much harder than installing a soft top kit. Just remove the parts off the m1167 and swap. Once I get the M1167 I'll be selling whatever I don't need in...

Yes. I'm going this week to pick up parts unit. So until I have the fuel system back in place I'm not going to attempt to start. .I may bid on a few more they have at the location. Got the mep fever. [emoji23]. I've always liked rebuilding stuff since I was 16. Here's a few of the trucks I've done

My shop air is a atlas copco 185cfm compressor. It does wonders with a blow gun! This is like the one I use.

Cleaning up in the works. Waiting to pick up parts unit next week to get it all put back together.

Any good way to clean this out? Compressed air or alcohol bath?

If I want to j Getting ready to try and start this. Where do I disconnect VR at? Thanks!

I'm not bringing those other two in. The camo is parts for the one this thread is about. The green one is a runner and will be kept. Just the fuel solenoid and associated parts was $240. That's what the camo one is for, a long with aux fuel pump and lines.

Camo parts unit $250, Green $1000 runner with 251 hours.

I had already bid on a stripped down 1165 that went to $4500. If I had know that I would of bid on this one. I watched this one but thought I'd win the other one for $3000...

I just picked up another mep802a for $250. It has all the parts I need to make this one a whole unit! I may have another, waiting on this next auction. So I'll be parting out a bunch!

Are the relays the same? Meaning same part number.

Found tag that says will not contact load. Tried replacing k2+switch.

I know the guys from Wisconsin and Michigan. Always nice! Helped me fill up air on tires, even offered to lend me a hitch when mine was too low. Never had an issue with govplanet except for the sf97's. But that's a whole different story. He did tell me they just have a shop light they plug in to...

Beyond economical repair, various missing / non-functioning components. Found in plastic bag attached on side of unit.

Thank you! And I thought I was dragging mine home too low. [emoji4]. I plan on buying a few more of these but no trailers, much easier to bring my own. I will tell you that it pulled like a dream 290 miles!

Yes exhaust flap in place. The other two that were listed didn't have them. That's why I bought this one. It was still there.

She turns over. With the starter and by hand. So no frozen engine, thankfully.

Gauge panel pic.