Search results

The galvanized piece is a heat shield that goes over the exhaust manifold. P/N 12339175. there is another small piece that goes on the end.

Check this: 5740072 gasket

Deleted

I found Spray Carburator Cleaner works great for unsticking stuck fuel pump plungers.

Some questions to help us understand the problem better. Did the unit ever run correctly before the single phase conversion? Did it ever run correctly after the conversion? Is the engine laboring, like it's under full load? Does the current go up immediately, or only when the contactor is...

All that rust makes me wonder what the inside of the frame rails looks like.

Take out one of the HID bulbs and compare the base to a halogen bulb. You may be able to replace it with a regular h8 or similar bulb.

At todays' prices, they just need to fill the tank full of diesel.

Well, my curiosity got to me, and I did some further research. One of the NSN documents I found says it is a pressure output port, but not for what purpose. Possibly for a capillary to an actual pressure gage? The doc states "sensor shall have one pressure input connection, one electrical...

That's why it MUST be disassembled, so we can all know. Curious minds want to know....

Could be a small tube they use to purge/gas fill the sensor, then cap it off. Try unsoldering the cap like end piece.

Very reliable machine. You can always buy new sheet metal from miller. I would buy it.

If it is a close fitting joint you might be able to use ABS pipe glue. I have used that on ABS ducting, and it worked great. For larger gaps I have used JB weld Plastic Bonder Structural Adhesive, and Permatex Plastic Welder. If you want a dual syringe with a gun and mixing nozzle, you can get...

Just buy it. Nothing that a hacksaw and welder can't adjust to make it fit.

Looking at the weight difference, makes me wonder if they are all nylon belted, and not steel belted. I could not find that info in the description, but I did come across this statement in their description " The intended purpose of Mud Terrain tire types is off-road use. They are not designed...

Solved that problem. Bought the wife a Blue Parrot trucker headset with bluetooth. She watches her movies on her phone, and I have not heard from her since then. :LOL:

I have not disassembled one of my humvee shocks, but have cut open other ones. Caution, the shocks are presurized with nitrogen. Drilling a big hole too fast will get you sprayed with oil (think of it like drilling a hole into a can of spray paint). I would drill a small (1-2mm) hole on the far...

I was not thinking that Meltons were bad. More along the lines of something happened to the original engine, to be replaced, and the replacement engine is now also missing parts. Btw, congratulations on getting an ambulance. I have been looking at them as well, just no room for one right now.

Have you tried turning over the engine with a breaker bar and socket on the crankshaft nut? I do that on any "unknown" equipment I get. The fact that it shows low milage, but has a Melton rebuilt engine make me wonder what happened?

Be careful when driving in the new seal. I wound up knocking the seal backing spring off the seal. I must have tapped it too hard. I just saw the spring hanging on the output shaft. Talk about a pain, trying to get that spring back around the back of the seal, while the seal is installed. I...