Search results

  1. doghead

    Winch problem on a fire dept M54A2 5ton

    As for the engagement lever, I often slowly pull out on my cable a bit while holding light hand pressure on the lever until it engages. Remember, the engagement dogs only engage every 180 degrees of drum rotation. Since your cable is bound, you will need to rotate the input shaft several turns...
  2. doghead

    Winch problem on a fire dept M54A2 5ton

    I suggest that you do NOT use a new shear pin to run the winch in reverse to unbind your cable. I suggest you get the engagement lever on the winch into free spool. Then pull the cable out. If you put the pto in neutral and rotate the driveshaft by hand(pipe wrench, or bar through the yolk)...
  3. doghead

    Winch problem on a fire dept M54A2 5ton

    I have them in my hand. Will send you a PM.
  4. doghead

    Winch problem on a fire dept M54A2 5ton

    I have the correct Mil Spec 5 ton shearpins for your truck, PM me your address and I’ll send you some. Just need to go find them... Will report back in a few minutes to confirm I found them. PART # 7409348 NSN 5315-00-209-7979 , 5315002097979
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks