Search results

  1. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    Speaking of push tubes. Again, IIRC, the small cam and big cam are different lengths. Don't mix them. Again, IIRC, SC are longer. Funny how you know things and when what you know isn't used, it goes away.....
  2. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    IIRC, 2 different lube systems, one is FFC, full flow cooling, the other DFC, demand flow cooling. One has a stat that controls oil flow through the cooler to only flow when upwards of 230 degrees, DFC. Hard to see if the BC has that system from the pictures. Even though the BC is probably older...
  3. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    NTC likes to eat cams too if it is over fueled.
  4. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    Where are the cracks? Some counterbore cracks were/are acceptable. Cracks from water passages to the counterbore are easily repaired with a threaded insert. Pics?
  5. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    Exhaust port size was reduced to speed exhaust gas flow. They are interchangeable, can be mixed on any engine, SC or BC. Only thing difference is the hole in the intake. ReCon heads come with a plug kit and include the 1/16 inch PP to plug the holes on early heads for turbocharged engines...
  6. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    Lift has no bearing on the plunger seating? Explain that. If there were no duration, or outer base circle, carbon would be pushed back into the injector cup, then you'd be changing injectors constantly.
  7. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    Heads will be fine if it is turbo charged, if not, you need to have the hole into the intake. 400 injectors will not work because the cam is different. More lift on the 400, .266 V.S. .176 IIRC. Even if I am wrong on the measurement, the BC is WAY different than the SC, you will have a smoke...
  8. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    Using the heads from the donor will work providing there are the correct ones that have the hole drilled in them into the intake port. How do you propose to just drill the holes for the PC nozzles? IIRC, the supply galley isn't even there in the non PC engines, they are targeted also, so it is a...
  9. WillWagner

    Engine failure, rebuild, with turbo, jakes.

    Upper bearings are the wear point. What do they look like? If you get new bearings, make sure they don't give you the ones for the non stud/nut rods. The oil hole is offset and you will not oil the piston pin. Ya know, you can take the push tubes out and you will be fine. It will be hard putting...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks