Search results

  1. Floridianson

    M977a2 throttle issues. Need help!!

    Been a long time but one of my 939 series the wire going up through the high low leaver to the button was a ground wire. Yes I checked it for being a ground wire and if it could ground out then it would engage the solenoid when we do not want it to. Have read some say the same wire is positive...
  2. Floridianson

    M977a2 throttle issues. Need help!!

    Just spit balling could the Trans. lock up solenoid be staying engaging when you go into high or low and releasing the button be pulling down the motor?
  3. Floridianson

    Hercules LDT-465 - significant amount of diesel in oil even after FDC bypass

    He is replacing the whole IP is what I was reading not the Head and that is the way we do it. Booster will put a lot more fuel in the crankcase than the flame heater because the flame heater puts it right into the intake. Booster at 60 psi leaking seal dumps it into IP and right into the crankcase.
  4. Floridianson

    Hercules LDT-465 - significant amount of diesel in oil even after FDC bypass

    In this case if the truck was running good and you have not removed the IP yet maybe just do the booster pump alone. It's work but not to hard move motor over. Also as said look at the oil feed to IP rubber line while your there.
  5. Floridianson

    Hercules LDT-465 - significant amount of diesel in oil even after FDC bypass

    You can remove the IP any time you want without lining up any timing marks. On install before we install IP or the IP drive gear we can set the IP head timing and harmonic balancer. I just find it faster to set the harmonic balancer on #1 TDC before removal of the IP. Then we set the IP timing...
  6. Floridianson

    Hercules LDT-465 - significant amount of diesel in oil even after FDC bypass

    So you looked over both manuals? There is the TM9 and the LDS trouble shooting manual here on the board. It might seem difficult but it realy is not that bad of a job. Also if you decide to replace the IP remember to replace the rubber oil feed from block to IP. Was going to tell you to call me...
  7. Floridianson

    M818 Transmission breather leaking air

    When you have air leaking out of the transfer case vent the sprag shaft seal to transfer case is leaking. Some rebuild kits come with the new seal that we can replace when we R&R the sprag piston and cylinder.
  8. Floridianson

    M818 Transmission breather leaking air

    Your sprag cylinder need R&R. As someone said no O rings but TM calls them preformed packing. You can wait on buying parts if you want because you might just need the two preformed packing and two new copper crush rings. Or you might need the kit that has new cylinder to if yours is rusted out...
  9. Floridianson

    Dogging in front med duty wench

    Yea had one that needed a little help with the lever to engage. Myself I drained checking for water. Then refill and working the lever back and forth Fast and Furious as many times to wipe the corrosion of the metal parts. To add I had my son in the cab ready on the clutch if I could no...
  10. Floridianson

    M35a3 screeching noise

  11. Floridianson

    M35a3 screeching noise

    To the OP glad you found the trans problem. Reading the TM's sure does help.
  12. Floridianson

    Found on FB

    Yea seen where someone did some mods to one and used it in a ultralight aircraft.
  13. Floridianson

    Increasing the air intake in a deuce

    Don't get your panties in a wad and please DO NOT tell me what I assumed and yea I should have said driveability or waiting for the turbo to spool up. This is and will be discussion and learn sight. Heck you even learned that the compression ratio is 22:1 not 24:1 on our Deuce this week thanks...
  14. Floridianson

    Increasing the air intake in a deuce

    Thats funny most people that say they bypassed there FDC and adjusted there fuel are happy with the way the run now and feel the differance. You ever bypass your FDC or do you still say you like it being there. Nothing wrong with a little fuel in your oil pan and keeping the military fuel set...
  15. Floridianson

    Increasing the air intake in a deuce

    Will agree the intake with engine coolant running through it and no inter cooler not the best for making power. The turbo that is spec out for the multi to run at 2600 rpm or 2850 rpm for the LDS and make good power in all the RPM range. To big and you might loose that range. Saying put a bigger...
  16. Floridianson

    Increasing the air intake in a deuce

    You would be surprised at what you get with just a Pyro, FDC bypassed and playing oops adjusting your twin nuts. When we talk about the 7 o clock position on the fuel control unit assembly that is not even a full plunger of fuel. How often do you drive around at 2600 RPM? I would not replace...
  17. Floridianson

    Battery Box Slides

    Yea was replying to 162tcat that said his 939 series batteries were next not his Deuce. I had two 939 series one I did the battery relocate and the other I said it was a waist of my time and money. I was just pointing out in the 939 series as long as they as tied down correct and sealed...
  18. Floridianson

    5 gallon fuel can mounting

    Broken left femur, left hand nerve damage and right eye loss of some sight. Yea no fun there just glad it was a company truck that hit me and had 300k insurance. Bad was it was my new truck with little mileage good was I had gap insurance and truck got paid off by the insurance.
  19. Floridianson

    Battery Box Slides

    Yea 162tcat while the 939 series batteries seem to be in a strange place it also will keep them from shorting in salt water so higher is better. Had my batteries shorting in just brackish salt water in my 816. My 939 series came with 6T sealed batteries under the passenger seat so safe around...
  20. Floridianson

    5 gallon fuel can mounting

    Yep best place. Water on mud flap not fuel in case of accident no fuel spill. I do not know about everywhere but Fl. if you caused the accident you pay for the clean up and just guessing fuel spill clean up is $$$. Not my fault so I did not have to pay and no fuel spill still clean up to the...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks