Search results

Truck is a 2003 M1078A1, So we’ve had temps in the teens to twenties (F) along with some flooding over the last few days and after driving my truck through some of the standing water (foot and an half or so) then parking over night I’ve had real problems with my rear parking brake releasing...

I'm looking for an interior / exterior temp gauge that would fit in one of the cut-outs for the rocker switches in the dashboard (44mm x 22mm). Anyone have any luck tracking something like that down. I bought one of these but it doesn't quite fit (too small). Any suggestions great appreciated.

Has anyone been able to source locking T handles that fit the existing cut-out for the panel stowage doors on the co-drivers side of the truck? I tried searching the forums but didn’t have any success and have been poking around online but haven’t found any there as well that fit in the...

I thought these were just standard 12 pt bolts but I haven’t been able to get either metric or SAE drivers to fit on it. Any guidance much appreciated.

I picked up a 2003 M1078a1 in mid-February of this year and have this forum (and its members) have been a huge help in helping to fill-in my meaningful knowledge gaps so I'm looking forward sharing the mistakes I make - so others won't make them and give back to what has been a great community...

I was doing a quick PM once over on my truck today and noticed a bit play - about 1/16" - between the starter and the starter flange (video below) - which means I'll need to pull the entire starter off to tighten the flange. I'm assuming there is no such thing as a "good amount" of play...

I have an interesting issue where just the rocker switches on the right hand side of my dash won't light up. I have an M1078a1 and the 12v rocker switch in the middle of the dash lights up as do all the rocker switches on the left hand side but everything on the right (master power, strobe...

I'm missing several tie-down rings in the bed of my M1078a1 and not only can't I find any online but I can't even find the NSN for them - I've gone through my TM this is one part not covered in the bed assembly (209-1) or sub-assembly (212-1). I've circled in red below what I'm looking for...

I am about to embark on a series of cab upgrades on my M1078a1 (interior lights, exterior lights, cab audio, etc) and my plan is to add a secondary fuse block and run it all off of 24v. I’ve read through the multiple battery and alternator threads (which contain great information) but don’t...

So I picked up a 2003 M1078a1 last week with 8,700 miles on it. What a learning experience this has been so far - all part of the journey. I picked it up late on a Friday in Idaho and drove it 500 miles overnight to California on what was a relatively uneventful drive. The prior owner...