Search results

I have a Case CX135SR excavator I purchased in Virginia. Looking to see if anyone can help get it back or suggest a reasonable hauling company/agent. Item stats: Weight: 31,000 lbs Length: 23'9" Width: 8'6" Height: 9'0" It is ready for pickup as soon as possible and it can take however...

I purchased a secondary tank for my truck. The sending unit is toast and all the other lines are cut. I also don't know specifically what parts I need to convert to dual tanks. Has anyone done this and know what parts I need to purchase? I found some parts but I am unsure so I am looking...

Looking to get my 1992 M934A2 insured as a Class C RV. I already have it registered with the state as a Class C RV but so far nobody wants to insure it. Anybody have suggestions on which insurance might cover it? BTW, I converted the cab/van portion to a walkthrough. Hence, Class C.

Had a power outage last night. Turned 803A on, switched house power to genset power. It ran fine for 5 hours. Then there was a VERY short power fluctuation. Woke me up as my A/C unit beeped during the fluctuation. I went outside and the genset was running fine. No stuttering, nothing. I...

I just got a WDR1-270 3Kw generator with 200 hours on the unit. It will not start. I used the T.O. listed in this forum, 35c2-3-499-1, and followed the troubleshooting guide. No fuel is getting to the injector. The engine will start with a shot of starting fluid but will not keep running due...

I want to post a few pics and so forth of my build so far. I started a little while ago but as I am slow, I wanted to get a few areas done to start this. Here is the truck as I picked it up. Here is the van extended. I am taking out the ducting, lights and unnecessary wiring. The A/C...

I would like to have a winning bid item picked up at 3100 Creekside Parkway, Lockbourne, Ohio 43137 and then shipped via UPS to Bonners Ferry, Idaho 83805. I will provide exact destination address via PM if you would like to do this for me. The total weight of the two items is 60LBS, 30LBS...

I am converting my rig into a camper. I believe the amp break down, on the 400 amp alt, is 350amps at 28v and 50amps at 14 volts. It is a Niehoff and has the regulator with it. I have the cta8.3 Cummins engine with no extra goodies installed yet. It looks like it will fit, with maybe a few...

I have been reading the TMs to find any Van specs. Nothing surfaced. I am putting a fresh water holding tank in the van, under the bed frame. It is a 120 gallon tank. So, a little over 1k of weight in one quartered section of the van. I don't want to cause bending issues with van floor. I...

My truck, M934A2, would not start this morning for the first time since I have owned it. I checked the fuel lines as suggested in other forum posts and found that the fuel line where the small filter is located is sucking air. You could hear it when I pushed on the filter and line. I looked...

Verify this rear air break line on M934A2 I want to make sure I am ordering the correct air supply line for the passenger rear brake hose for my 934A2. TM info is 4720-01-112-6577 P/N 12256271-5. The other hose shown I think is for the drivers rear break hose. 4720-01-112-6576 P/N...

I read a few wiper threads and ppv threads but this is a little different. My passenger wiper was not working. Planned on fixing it toward spring. Drivers was working fine. Today I gave it the weekly startup and minor function check. The passenger wiper started working! Great huh? I turned...

I called to start thr title process on my M934A2 and she asked if it had a FMVSS (federal motor vehicle safety standard) sticker on the door. If not, then they couldn't title it. Of course it doesn't have it on the door or anywhere else. How in the heck do I find this info? Why do I always...

I have seen a few 934s with a lift gate installed. I have also been looking for one to install on my truck. So far I have had no luck and it could be because I am unsure what will fit. I don't care if it is original or aftermarket, does anyone know where to get a lift gate for these trucks...

I looked around at a few military surplus sites and did several searches in this forum (dash indicator lens seal, indicator lens, indicator seal, dash lens, dash light seal, etc). I need to replace all the rubber seals and two lens caps. Could somebody please provide a source for these...

It took some time to get things going but I finally got the genset running. Not that it had any problems. I had problems getting the fuel/water filter off. What a tremendous pain in the butt. I don't think anything has ever got me so angry. I read on here the problems some of you have had...

;) Okay, I am taking the wheel apart to put on new tires. I had to get a new/bigger torque wrench to get the nuts to come loose. Now I have the nuts loose but the rust from sitting and never being cleaned is holding them very tight (along with the distorted lock-nut characteristics). I am...

As stated, won a generator today. I paid more than I wanted but between the trailer and the genset I am happy. The power went out here twice last month. Once for over a day and the other for about 7 hours so I decided to get a generator. We just moved up here so I imagine this happens...

What would be a good trailer for towing behind my M934? Like ATVs, maybe even a car. In other words heavy duty but pintlehook style. I already have a standard dual axle tow behind. I was thinking M110 but longer. What have you used, what do you suggest?

How do know if one of these trucks has been rebuilt? Is that where the A1/A2 designations come from? Then, how do you find out when it was done? I keep seeing private sellers saying a truck was 100% rebuilt by the military on such and such date? That is why I am asking.