Search results

From what I've read, I would have been in permanent 6x6 if the lines were crossed.

No rebuild on this old girl. she has all of her 35k miles on her. I think it was a Maine or NH National guard truck. A couple small drips here and there but runs great. CTIS was neutralized when I got it so I've removed the valves at the wheels. Other than that, no real problems until the...

And let there be 6 wheel drive. Thanks for the spot on diagnosis. The piston was backwards with the deeper cup facing the wrong way. The pics show the piston before and after removal.

I'm actually excited to crawl under there today knowing this should actually fix her. As soon as I get home from work later, I'll be under there and let everyone know how it goes. Thanks 162.

I,ll give that a try tomorrow. It doesn't seem too hard to get to. I guess opening it up will tell me if there are any other problems inside the piston.

No go in low range either. I was thinking that the air I hear escaping means not enough psi to the actuator switch that is activated by low range since the manual switch air runs through there as well.

It will turn when when moving forward under power form rear wheels because no lockout hubs. To test it, I put front tires in snow bank and rears were on the iced over driveway. The rears we're spinning while in drive and the fronts did nothing and front shaft doesn't turn, telling me it its...

Front axle won't engage M923A2 So after getting stuck in the woods this weekend with no 6 wheel drive, i decided to fix my lack of one axle turning. I started by addressing some things that needed fixing as preventative maintenance or to eliminate as added issues to my problem. I replaced my...

Sorry, I was frantically trying orchestrate removal while I had daylight and didn't break out the camera.

While scouting out a remote sand pit the property owner offered up for a shooting location. The unplowed road turned snowmobile trail turned mud bog with no where to turn around, Quickly became too much for my m923a2 when the font axle would not engage. I called A HMMWV that tried to pull me...