Search results

He picked up my 5ton for me years ago at Ft lewis. First thing he said was THEY GO FAST! ha! I am not sure if you see my name or not but tell Brad you have been conversing w/ Brad the plumber in SO Calif... Mike this is the throttle posistion switch I believe yes? It looks like I need to...

Mike, BE SURE to tell Brad Milne you and I have conversed... I am SURE he will tell you about our run from Los Angeles to the PNW, he in my 5ton loaded w/ 10000 pounds in the bed AND pulling a 8 wheel trailer w/ a 20' shipping container on it and me in the 20 ton hauilng the same. OMG! Brad...

Thanx Mike... I think it is already on the new engine... I will photo it and verify. Mike can you name all these sensors? The new engine has just one (the center one ) on the drivers side... https://www.steelsoldiers.com/threads/artisans-m916.122713/page-30#post-2269280

Mike excuse me I did not see this. ( I speak w/ Brad Milne about once a month just because...) So the BC1 engine were pulling out had jakes. The new BC3 has jakes too. Shouldn't I just be able to connect the 3 wires at the top of the engine and it will work ok? EDIT: We have a resolve for the...

Wes and Mike consider follwing my thread! (Mike do you know Brad Milne in WA? ) I need all the help I can get! ha! The TM says I need 3 Assistants, PLUS me! HA! I had one guy for 45 minutes so far pulling the rear two motor mount bolts and assisting on the lift to remove the old engine...

Thanx Mike, I assume it is a normal right hand thread...

I see said the blind man as he picked up his hammer and saw. THANK YOU! THANK YOU! THANK YOU!

Mike, I found a dial indicator that doesn't break the bank... I wish spinning the crank was that simple and do I have to go one particular way only ? As you see there is no center nut...

So if you care to lend advise (or watch me make mistakes) my Notes / SS Blog is here; ARTISAN's M916 https://www.steelsoldiers.com/threads/artisans-m916.122713/page-30#post-2269989 I have a NIB Military BC3 that I am putting in my M916 and pulling the bad BC1. As I understand it, I have to...