• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Search results

  1. R

    Mep-803a high idle

    The other reason it may feel sticky when loose in your hand is that the plunger is fully extended and the spring is causing the plunger to "Bottom out" in the body. Once installed the tip of the metering pump touches the cam follower and slightly compresses the spring and plunger, eliminating...
  2. R

    Mep-803a high idle

    With the side cover off you will have good access to see if there's any junks in the bottom of the block, but stick your fingers up in the area around the fuel rack and the lifters and make sure there aren't any chunks sitting up on the ledge. Poke around on the internet looking for new metering...
  3. R

    Mep-803a high idle

    A quick note before you pull the injectors. If you'd like, disconnect the fuel shut off solenoid linkage at the black knob. then using your hand, twist the shutoff lever left and right through it's range of motion. You should feel very little resistance for a bit then feel a noticeable increase...
  4. R

    Mep-803a high idle

    Looks like your video did not get posted, I just see an empty post with no attachment. As for the governor, it has to be serviced. It's a series of weights and springs inside the timing cover, near the throttle linkages. You'll need to pull the timing cover and crank pulley to get in there, but...
  5. R

    Mep-803a high idle

    You are correct, don't ever hook up to you house until the machine is fully tested, repaired and you know it's working correctly and reliably. Use something else to test with like heat guns, an old oven, portable heaters etc.
  6. R

    Mep-803a high idle

    P32pac, so that I understand correctly are you saying you can move the throttle through the full range of motion on the lever where the cable attaches and the engine speed does not change at all? If so it sounds like you have a problem inside the governor assembly. You also said it smokes a...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks