• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Search results

  1. dhaumann69166

    What have you done to your HMMWV today/lately

    Put a new set of tires on the Humvee yesterday. While I had the tires off I drained the hubs and filled them with fresh oil. One of the tires I got had water in it so I had to take the rim off and vacuum the water out. Also swapped the wheel out for an old one I had in better condition. The...
  2. dhaumann69166

    What have you done to your HMMWV today/lately

    Looking great!!! Are you going to be able to use factory air intake? I only ask because I have a deep water ford kit and when I do my Cummins swap I want to keep the DWF kit as intact as possible.
  3. dhaumann69166

    What have you done to your HMMWV today/lately

    Put it all new glow plugs. Luckily none of them were swollen and all came out easy. Took about an hour to change all 8.
  4. dhaumann69166

    What have you done to your HMMWV today/lately

    Put a new input seal on the front right geared hub. First time I have ever messed with the geared hubs but it’s simple. Took just over an hour including tool clean up and filling it with oil. I made sure to spin the hub a few times while filling it with oil to get all the air bubbles out of the...
  5. dhaumann69166

    What have you done to your HMMWV today/lately

    I think the adhesive should hold in summer heat. I had the shop heater a little to close to the door and it was a little to hot to touch on the outside so just out of curiosity I pulled on the foam on the inside and it was stuck hard! I think as long as you start with a good clean warm surface...
  6. dhaumann69166

    What have you done to your HMMWV today/lately

    Also need to add that you need to have your body panels warm. I had a Val6 blasting from the outside and space heaters inside and blankets on the roof to hold the heat. First night I didn’t get the roof warm enough and it didn’t stick in a few spots.
  7. dhaumann69166

    What have you done to your HMMWV today/lately

    Last night I got my insulation installed on the ceiling and doors. The aluminum doors and top sucked up a ton of heat. I used 1/4 closed cell foam with Mylar on both sides. It was $70 for 100sq ft (25x4) way cheaper than dynomat and does the exact same thing. I was amazed how much it reduced...
  8. dhaumann69166

    What have you done to your HMMWV today/lately

    My 1038 had airlift rear bumpers on the front and back. It made it look like it sat low till I chopped the front down to 44” long. The back looks a little low but still looks good I think.
  9. dhaumann69166

    What have you done to your HMMWV today/lately

    In the last couple weeks I have done quite a bit to my M1038. The hardest part was wiring. I had to completely build and replace the main wiring harness coming into the cab. After lot of wire chasing I have lights and everything else in the cab works again. Got all my heater controls unstuck...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks