-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
O
What did you do to your deuce this week?
Poconos eh ? Juniata County myself -
O
What did you do to your deuce this week?
Forgot to add yes its a weld in replacement from Memphis equipment -
O
What did you do to your deuce this week?
I cut out the rotted section and started cleaning up with a flapper disk , I made a new reinforcement out of 3in 1/8th wall box tubing. And I just need to weld er all up , and yes the hard lines are about half annoying, but they will pay off -
O
What did you do to your deuce this week?
Been stuck in restoration pergotory last couple of years, installing all stainless fuell system with an fitting , going with hardlines and ptfe hard crimp stainless fuel lines. Replacing all the old plastic return lines with .25 stainless hardlines , and finishing up with the rocker panel... -
O
What did you do to your deuce this week?
Ordered a laundry list of parts,Cut off all the old brake lines and began sandblasting things. Now if it would stop raining for a few days...... -
O
What did you do to your deuce this week?
got a 4 1/2 inch angle grinder , can finish up the frame cleanup before her new body goes on . also pulled the hubs off to check before i did a complete rebuild , they were overhauled in 85, nothing needed replaced except the lines -
O
What did you do to your deuce this week?
got the radiator back from the shop, got her all hooked up , new hoses water pump re-installed, everything is good , just need a wiring harness yet before i can change out the filters -
O
What did you do to your deuce this week?
i pulled my winch , that thing was HEAVY. i think i might have pulled something picking it up since the next day i was so sore i needed to see my chiropractor. the radiator is off being boiled out and pressure tested so that is out of the way , need to get the drive train fluids done, tranny... -
O
What did you do to your deuce this week?
what did that run ya aaron ?just for the blasting i mean -
O
What did you do to your deuce this week?
got my bed off and started removing the scale with a needle scaler , makes quick work of it , got my pintle hitch fixed and greased , ran out of grease before i got to much more , and ordered filters -
O
What did you do to your deuce this week?
mike, the rocker panels need replaced , and the corner closest to the engine bay is rotten out so with the doors off repairing them is a lot easier -
O
What did you do to your deuce this week?
i got the doors off, and the brakes bled, also i got to drive her for the very first time, i feel , fully content -
O
What did you do to your deuce this week?
my truck lives again, the hydraulic head has been repaired , and now she runs like an Swiss watch. winch works but is a bit iffy at the moment , the lever is prone to sticking , and im quite sure if i put a load on it at the moment that cable would snap and kill whoever is running the winch -
O
What did you do to your deuce this week?
finally finished de-rusting and painting the tank, got the lifter pump assembly all back together , and installed a new primary fuel filter -
O
What did you do to your deuce this week?
got my needle scaler from harbor freight , along with a new turn signal and gasket set, been using the scaler to remove aprox, 9 unusual colors of paint from the tank,(works like a dream). tore off my operators side fender assembly for cab repair, and re-paint. cab corner is BAD, i mean i... -
O
What did you do to your deuce this week?
i ripped out the seats,turn signals,heater core , heat shield from the exhaust, removed the tailgate and troop seats, fuel tank , oh and only after i did this did i remember to start taking pics, followed that up with shop-vacing out 3 squirrel nest and atleast 1 dead squirrel. drained the...