Recent content by badgerord

New GI ignition switch failed to fix it.

Original USGI everything, It works with the original SSS, the starter solenoid is not stuck, when we disconnect batts it comes out of battery. when we re-attache batts it doesn't do anything till we start it again.

Hi all, Just added a new KDS Smart Start System, truck starts right up, but starter will not stop. Even if the start switch is turned to OFF. Disconnect battery, reconnect, everything is normal till you start ism then the cycle starts again. Last one got fried due to a helpful helper...

Yes it does, and a cooler !

Well it turns out there is a bunch of Aluminum in the pan, need a new tranny. Who has reputable rebuilds ???

Looking for some insight from the mind hive. My 1986 M1044A1 HMMWV was running great, took a 30 mile road trip to visit a buddy that just bought a new plane. As I approached the airfield I had to stop at an intersection, when I pulled away from the line had no 3rd gear (3L80 Tranny) after a...

Missing a few straps and the rear cushion. It is stripped a bit right now but I will get it back together in a couple weeks and post some pics.

Arrrghhh! Thanks!!

HI, Do you know if there is a 718A1 specific manual? Something that talks about how the medics utilize it?

Mutts will normally need the choke to start cold, because they do not have a fuel pump in the carb and when they sit for any amount of time the fuel starts to drain back to the tank. You need your carb rebuilt by Brooks engine. I have 4 mutts, all have Brooks rebuilds. I have rebuilt carbs...

Who has parts for IP's and HH's??

We checked the torque, it is tight. Thanks for the heads up!

Hi All, On the HH, there is a bolt in the center of the hi pressure distribution lines, Can that screw be removed w/o disassembling the whole HH? I have a fuel leak from that screw and am curious if the seal on that bolt can be replaced w/o major disassembly? Thx Marty Badger Ordnance

THANKS!!!!! that's the stuff!!

I have looked at all the TM's available on the site, what manual shows the rebuild process for the 6.2L engine? Also need a complete parts breakdown of the engine so I can determine what the P/N's I need are.