Recent content by bigbird1

M880 Dodge 8 lug wheels , V-8 , northern Indiana if anyone looking for parts. Located in Pauls auto yard Demotte Indiana. They do not keep cars more than a few months. posted 8-22-21 Sorry your on your own pulling parts.

Last two posts are spot on, I too got some Droman junk and sent them back , not even close. I took the to a hydraulic shop and they cut the crimps off and used my old lines with new hose and clamps , charged me like 57.00. NEVER BUY THE DORMAN LINES!!!!! One of the lines had a worn...

Make sure you have the correct rear support bracket, direct drive and gear reduction starter support brackets are not the same.

Guys, around here scrap yards are only paying 20$ a ton prepared (4ft or smaller). Its not worth the gas to cut one up!!! I Bet its along a trail somewhere, Hope the find the scum that did it.

yes, As said, both rings are good, factory rings from warthog are most likely made by one of the two companies. Check the rod bearings on the top side, if you see anything but gray change them, No copper or scratches. Be sure to check valve seals they break down over time and let...

That's Great, good job finding the problem. That's one of the note to self moment ( remember to never do that again) lol

Try pointing the injector straight up and hooking pressure line up and watch it ( have done it with tractors and it works), be very careful stay far away , fuel can shoot right through your shin and a hospital visit will then be in order. Then that will tell you if the injector and pump...

It ran fine before, just blowby. cam is not likely the problem. The compression check will tell him where to go from here. Maybe broken rings, or no fuel passing the injector, or even wrong valves in prospective holes. Anything could happen, but we hope not in this case.

Better do a compression test. Did you have any trouble with that piston going in hard?

Any deals, I wanted to go, but I painted the m1009 instead.

Nice blazer, I love the tan.

he has filters but no bases, I just sent a email couple days ago.

What do you use for floor liner? Also any good places to get a rear gate crank knob? Keep up the great work and pics.

just put a classic tube set on a 05 chevy 1500, very nice and near perfect fit. even stainless fittings on the ends. I would use them in a heart beat. I also put every line in the same holder for the factory look. still took about 4 hours to put on, But most take 14 hrs to bend and...

Its hard to tell with the picture, but they should have a slight taper to them that is used to center the wheel on the hub. That being said if it rides close to the top crown of the lug nut than its junk.