-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Plasa's latest activity
-
That can’t happen unless your tires are over ~85 PSI or you are drawing CTIS air from somewhere else. CTIS(and the fan) pulls air from... -
Plasa replied to the thread CTIS and Arduino.One solution could be to check if pressure when inflating is below the preset. This means that there is not enough pressure in the tank...
-
The A1 still uses a high coolant temp switch, S26. Probably in the thermostat housing right front of the cylinder head. Fan control...
-
Plasa replied to the thread CTIS and Arduino.That's easy, it's just inverting the boolean value. But it's a risk because with no signal the controller thinks he have full tanks. So...
-
Plasa replied to the thread CTIS and Arduino.Hello! Yes, I use the wet tank input switch. There is no need to change any logic input, the original one close the signal to ground at...
-
Plasa replied to the thread CTIS and Arduino.Yes, they work also on A1R because no connection to the can bus is needed. The CTIS is almost isolated from the rest, except the speed...
-
Plasa replied to the thread Need LMTV CTIS Control box..Thank you :-)
-
@Plasa sells an Arduino unit. Awesome support. Lots of Funcitonality
