Search results

Thank you for some reason I missed clicking on that link! Thats the one!

Unfortunately the spec plate on the motor is unreadable so not sure of make or model otherwise I could look up the specs and wirk around it. Seems reasonable to start out at 1800 psi and take it from there. Here is a pic of the motor if snyone vould identify would be great!

Great idea thank you!

Thank you So I will not need to regulate the glow rate just adjust the auxiliary hydraulic circuit down to 1850 psi ? The Cat hydraulic circuits can be adjusted for PSI thankfully! Thank you for all the help!

Very much appreciated thank you!

I have a 20,000lb Garwood winch with hydraulic motor and adapter. Could anyone please tell me the correct original Flow rate GPM and pressure PSI that these motors run on. I am trying to adapt the setup to run off a Cat loader with 3000 psi and 32 gpm and I imagine will need to regulate flow...

Thats great then as it should be relatively easy to find a motor providing 300 ft lb at around 250 rpm. Any suggestions to where to source something like this ? Again thanks for the help.

I just found the spec sheet on the 20000lb winch and it quote RPM 250 and shaft torque at 3427 inch lbs does this seem correct?

That is great information many thanks. Now to find a hydraulic motor!!!! Im trying to build a forestry winch is driven from a backhoe hydraulic circuit. Thank you again!

Thats great many thanks. I can get a hydraulic motor that will drive at 240 rpm - you wouldnt happen to know the torque thats needed to drive the shaft by any chance would you? Again thank you for your help with this.

Thank you - it looks like one of the pictures I posted is not coming out well Ill post it here again to see if we get better results! Do you have any idea of how I could provide power to the shaft either by installing a hydraulic motor or by obtaining the original drive gear by any chance. Many...

Could anyone please identify this winch set up I have come across. I would like to convert what appears to be a cog pto drive set up to a hydraulic motor drive. Need to know the correct shaft RPM if possible. Any help very much appreciated Mark