-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
Decimal drill size chart.
It was some dirt rubbed onto the plate when the South Bend Lathe came out. I had washed most of it off but some was stubborn. The three phase motor on that lathe weighs more than I do, by a good margin. I try washing it again and rescan.- SCSG-G4
- Post #14
- Forum: TM Upload section
-
-
Decimal drill size chart.
The original scan is 1412 pixels by 889 pixels, and saved as a PNG file is 3.0 MB in size, and 3.3 Mb as a TIFF, JPG and BMP files are much smaller.- SCSG-G4
- Post #11
- Forum: TM Upload section
-
Decimal drill size chart.
It's a metal plate, with sharp edges, not easy to mail. it measures 9 3/8 inches (23.9 cm) tall, and 5 3/4 inches (14.6 cm) wide. Send me your e-mail address and I will send you the full sized scan.- SCSG-G4
- Post #8
- Forum: TM Upload section
-
Decimal drill size chart.
Uploading again, this time horizontal.- SCSG-G4
- Post #6
- Forum: TM Upload section
-
Decimal drill size chart.
The original scan is 3MB, when uploading it to the site, it dropped to 600K, that's why it's fuzzy! The upload process got rid of five of every six pixels. I may try uploading it again as a horizontal image to see if it is any better.- SCSG-G4
- Post #5
- Forum: TM Upload section
-
Decimal drill size chart.
I probably do. but this one was USMC and did not have the Army TM number with the gull wing.- SCSG-G4
- Post #4
- Forum: TM Upload section
-
Decimal drill size chart.
From a gull wing trailer being scrapped, here is a decimal to drill size chart from .0135 to one inch- SCSG-G4
- Thread
- Replies: 16
- Forum: TM Upload section