Search results

Rounded an edges knocked down with a sander.

.

Ask and you shall receive! It warmed up to a balmy 10 degrees this morning so I ran out there an got a pic for ya.

Just finished a few things. -Had injectors cleaned, tested, rebuilt as needed -Pulled Y pipe off an had an exhaust shop bend an flare a new piece of pipe on the driver's side that bolts to the manifold as the old flange rusted off -Replaced cold advance solenoid -New prefilter for air intake...

After some calling around trying to find a local shop I trusted an would be willing to work on a Humvee I was able to talk a shop into it-barely. :) So I replaced the pitman arm an one CV shaft just in time to make my appointment. I had them mount 2 rear tires an wrestle the run flats in them...

Backdraft Preventer "Not the movie" :) I made a "Backdraft Preventer" or divider if you will. There is a heck of insurgence of air that swirls up and enters behind the rear seats-especially for the passengers backside (aka my kids). Since the weather is getting colder the drop in air temp and...

Thanks. I did that too, but the biggest problem I had was the strikers were in to far-up and down adjustment wasn't the biggest issue. So I had to move the strikers out in order to get the doors to close completely.

X Doors Got my X doors on finally after messing around with them every night after work this week. What a cluster that was! Strikers didn't have enough adjustment so I had to hog them out some, then I had to "tweak" the strikers more this way an that way. Then the doors would hit the top rail...

Just got done with the following, took about 3 weeks to do everything between waiting for parts an going on a little family vacation. -KDS smart start box and TSU -Fan Temp Sensor -New rad hoses an coolant flush -Coolant heater installed in lower hose -Ground wire harness -LED headlights an...