Recent content by aredman

.

Alternator Pulley for Mep 802/803a. Part number 88-20003. 3020-01-382-8782 $45 shipped.

Do you still sell them?

And I have power at my lugs!

Well I just found another s-14 and swapped and she fired right up. Must have been pro Well I just found another s-14 switch and swapped, and she fired right up. That’s my problem.

Well maybe dumb question, am I suppose to be testing at actual terminals on relay or wires with Phillips screws.

Meant to say I get 24 volts at terminal 9 when I put in start position.

I got power at terminal 9 on K16. Not sure where to look after that. K16 doesn’t physically move.

Guy, I have never had start right since I bought it. I unplugged fault indicator with no change. Should say when I got it, was missing alternator and sensor that picks up flywheel speed. Forget the name. But all have been replaced. If makes any difference. Thanks for feedback.

Light comes only after I try to crank. Not before. Diagram helps. I’ll be home later today. Thanks

Only lights that come on are after I put switch in start position, then the low oil pressure light comes on. But never cranks

It seems other 24volt items work. Also no power to K2 so I assume solenoid would not click? K15 moves when I crank. I do see k16 move when switching back to off.

Hello I’m another guy that can’t get it start from switch. I have a 802a that bought that has never started from switch. Cranks fine from dead crank great. I do get power from terminal 7 on my switch when I put in start. No power to K2 though. Did swap some relays around and no change. Been...

If they run out of fuel, do they self prime easily, on the Yan Mar

Send a link sometime.