Recent content by av8or

Great!! I'm in.

Looking for a curved rear fender for a m915 thru m920 goes in front of forward rear axle. Will be there thursday on.

I had 2 m916 trucks that needed solenoids as they had 24 volt solenoids in the dash instead of 12 volt. both had just come from rebuild.

Jump the solenoid in your picture next to glove box. If that does not work jump the starter solenoid.

When MV that were sold as off road only showed up on the market people had to find a loop hole and get a on road title. The efforts to get around the intent of the law has caused the law changes, and law changes will continue as long as people try to get around the intent of the law. Just my 2...

The ones I mentioned are with aluminum frames, don't believe they are Korean probably Chinese, bought from government liquidation some time ago. I also have a few original equipment with steel frames $150 each.

M35 windshields will fit. I have a bunch at $100 each but shipping is a problem. I could bring to the Georgia rally if you know anyone who is coming.

The E 85 will thin the gum, drain, repeat, spray out with more E 85 through a siphon spray gun and a long piece of brake line to reach back corners to avoid tank removal.

Nice looking unit, always wanted one.

We are planning to be there Thursday thru Sunday. Always a good time.

Added a trail king TL40 to go with the M915

Just my 2 cents, my 445r65x22.5's or a lot larger in dia. than an 11r22.5. Like about 5 inches. (46 vs. 41) 1100r24 will match up better to the 445r65x22.5. In 1100 or 1200, 24.5" will be 3" smaller than 24"

welcome from Fort Denaud Fl.

Welcome from Florida and West Virginia. Spend 1/2 the year in Rainelle. Hope to meet you. Bob