Recent content by brandan34

I ended up getting the front cab mount for a 404(I think that is the model). They only have three mounts, one in front and the two on the back. Took a little fab work to get a spot to mount it. Then went to bolt it and I have no idea how they get room to install the back two of the three bolts...

What did the problem end up being?

the 4x lever is behind the cab you can see it if you look down between the frame of the roll bar as i show in the first photo. I have a lot of stuff removed not sure if you can see it on yours like i showed on the second two photos or not.

That is what i have read and probably will, though it is nice to have options and there are places i could see wanting to go that those parts would be under water for a few minutes

That is what i have read and probably will, though it is nice to have options and there are places i could see wanting to go that those parts would be under water for a few minutes.

See if the 4x4 lever on the tranny is moving when you turn the air to it on and off. It is almost right under the back side of the cab.

I am starting to see why they do that. If you use the split kind it does not have a spot for the airhose when you turn on the 4x4 and there was another reason that i forget now that ei thought like orginal was better. I do have a help ticket in with them. At this point i do not see it an obvious...

Has anyone replaced the boots on the axle shafts? I have one of the axles loose and I am now stuck. I do not see anyway to get the one piece boot that the military used over the ball on the axle tube and into place. Is this a case where I get some tire changing spoons and force it or is there a...

Checking in from the back of oregon

I went about fixinging mine the hard way. If you were closer i would offer to fix yours for the cost of a new one.

Look back in this thread there are a whole lot of posts talking about how to figure it out and suggesting some words that may help describe the project in front of you.🤪 Hey at least you have access to a wiring diagram those guys were just using the tm. Good luck and let us know what words you...

When you engauge the 4x4 it puts air in a few places in the drive train to keep water out. Those hoses should have around 5psi i believe. I would guess they should hook into the boot going forward and the boot going back from the tranny to the axles. Just push them back in. To be dropping your...

One of the front cab mounts got ripped off putting the cab back on, the other looks weathered. Ei has new ones for 260 plus shipping. Near as i can tell the flu419 front cab mount is one of a kind. Is there a reason they use that style? Wondering about changing styles to a more normal kind...

What is wrong with it? if it is just the shift fork on the lid easy fix, you seem to know your way around this stuff better than i so guessing it is more than that. The books are good to look at, i printed it off and even glanced at it a few times. Probably should have read it a bit better but...

Ouch, i can see why you are worried. How sure are you it is the tranny vs the rest of the drivetrain? Hoping rear end or tube to it could be bad if you have in 2 wheel drive. Can you engage the rear hydraulics?