-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
CallMeColt's latest activity
-
CallMeColt reacted to LCA078's post in the thread New to me M1097R1: Injector pump acts bad with
Like.
I did exercise the springs and levers. When I removed the IP cover, I could tell they were goo'ed up and not moving even though I could... -
Everyone, I've been troubleshooting this one for a few weeks now & am going to make a nice, long detailed post. Truck is a 1988...
-
CallMeColt replied to the thread New to me M1097R1: Injector pump acts bad.When you had the IP cover off, did you exercise the springs & flapper in there? The shut off solenoid pushes against a flapper. The seat...
-
CallMeColt replied to the thread MEP501 28v to 120v.Keep in mind if you use a direct inverter, you will not get the needed surge amperage so your output from the inverter will be reduced...
-
CallMeColt replied to the thread MEP501 28v to 120v.I didn't realize until just now your location... that makes things a bit more challenging. I have refurbished ones to sell but it would...
-
CallMeColt replied to the thread MEP501 28v to 120v.In my opinion, I'd just leave the MEP 501A as it is & find a MEP 531A. In the end, it will be way cheaper. Unless you want the project...
-
CallMeColt replied to the thread MEP501 28v to 120v.You won't find one of these small machines that generates power at 1800RPM. It's possible, but not practical.
-
CallMeColt replied to the thread HMMWV M1097R1 specific.There are not a lot of them, but M1097R1's with the "A2" power train are out there. I got one myself now too. They have some oddball...
-
CallMeColt replied to the thread MEP501 28v to 120v.I just saw this & the comment on you YouTube video. That was done quite a long time ago now, no surprise that parts are not longer...
-
CallMeColt replied to the thread Finally getting a military radio in my LMTV.Slowly working on it. Got the VIC-3 mostly installed, tablet w/ mount installed, and updated loudspeaker installed. Tablet with control...
-
CallMeColt replied to the thread MEP 803A Fix-up Thread.I always try to share, good or bad. Someone will learn from it. I feel like I know a lot about these, but this one for sure got me. The...
-
CallMeColt replied to the thread MEP 803A Fix-up Thread.So, been a while since I updated with this thread! After messing with it on & off in-between the 100 other things I have going on, it...
-
CallMeColt replied to the thread Various FMTV CTIS Rebuilding Kits.I'm no longer offering the CTIS Wheel Valve Rebuild kit. I will be offering what I have left of the o-ring & seal washers until they are...
-
CallMeColt replied to the thread Finally getting a military radio in my LMTV.Got a good, proper dual band antenna on the LMTV. May need to re-think it with the high. Swapped the radio with a different one that had...
-
CallMeColt replied to the thread VIC-3 intercom cable hookups.I'm not an expert, but the only reason it needs to have a full loop is in case there is an issue. I recently hooked up a VIC-3 Lite in...