• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Recent content by carc383

  1. carc383

    M1078 hydraulic leak on cab

    Thanks for information I really appreciate your help!!
  2. carc383

    M1078 hydraulic leak on cab

    Hello guys I’m having an issue with connection that locks cab down behind the cab . I’m not sure what the name of the part is. There is a hydraulic line that goes to it. When I raise or lower cab I am loosing hydraulic fluid . It’s coming out by the red tip on it. Any idea where to start ...
  3. carc383

    Allison transmission issues on a 1078

    Thank you I will try what you suggested. I appreciate the help Mark
  4. carc383

    Allison transmission issues on a 1078

    Hello guys I’m having an issue with my m1078. It doesn’t want to go into gear. Pressed all the buttons nothing happens. I press the mode button and the light goes on and off when I press the up and down arrows it give me a y code of d14522 . Any idea of where to start? Would appreciate any input
  5. carc383

    Hot batteries

    I have a m998 today used it ran fine but when I shut off everything is dead. Nothing works I checked batteries and they where very hot I’m thinking maybe alternator overcharged them I noticed gauge in red ? Is there a fuse or were do I start looking to find power again? I changed alternator...
  6. carc383

    Bad portal

    My m998 is an 1989 model it’s never been reset so I’m not sure what it’s got is there some numbers on unit I can look for to tell you what I’ve got and what would it cost for me to get one with you to get me back going
  7. carc383

    Bad portal

    I have a 1989 m998 that the right rear portal ran dry and bearings fried . TM say that if bearings are bad to change whole unit . What am I to do, they have new portals for sale on ebay for $875 but they are 12,1t00lb units. Would it be ok to put this instead of the 10,300 unit . I know I would...
  8. carc383

    GETT 23kw 120000btu - Applied Companies

    i have power on all coils .I checked on meter but the two outer coils have more voltage than the inner ones . I took the top panel off to take a look inside and ran it without top so no air was blowing across coils. There was a little orange around the ceramic holders but not a bunch when I...
  9. carc383

    GETT 23kw 120000btu - Applied Companies

    heater not working I ran unit a few months ago and everything was fine yesterday I tried to crank up heater and nothing any ideas when i ran it last i could smell the lint burning off elements like a heater smells for the first time in winter but this time nothing
  10. carc383

    fuel leak on a 804a

    I found it guys I ordered four of them just in case. I have three other units besides this one so I like to have spares I found some on oshkosh web sight for like $6.95 plus shipping.
  11. carc383

    fuel leak on a 804a

    Thank you that should get me going in rite direction I guess I was looking in wrong Tm thanks again
  12. carc383

    fuel leak on a 804a

    Can anyone help me with sourcing a part? My issue is on the fuel tank they have a rubber plug that kinda looks like a boat plug with a hole in middle thats threaded. I looked in tm and couldn't find tried contacting green mountain no luck your help would be verymuch appreciated if your looking...
  13. carc383

    Transfer case grinding

    I resently got another 998 and find that I have to turn motor off to change selection in transfer case. I put transmission in neutral to go to L or HL but unless I turn motor off it grinds Ahh not a good thing!! Is there an adjustment for this because it doesn't seem rite.
  14. carc383

    front turn signal

    :-?
  15. carc383

    Ctis issues

    thanks for info i will try if time permits later today when i go to my shop
Top