-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
cattlerepairman's latest activity
-
cattlerepairman replied to the thread m35a2 fuel filter leaking at bottom drain bolt / petcock.https://www.jatonkam35s.com/DeuceTechnicalManuals/TM9-2320-209-20-3-1.PDF Section IV. FUEL FILTER Page 143 ff -
cattlerepairman replied to the thread m35a2 fuel filter leaking at bottom drain bolt / petcock.Not sure what you refer to as "bottom nut". The canister housing has an interior threaded sleeve that is attached to the bottom of the...
-
cattlerepairman replied to the thread Cab bushings (mounts).Time for those little airbags that semi truck cabs use? Hitherto unknown luxury ensues! Sent from my SM-G991W using Tapatalk
-
After a long couple weeks, it's back to life. Plugged everything in, flipped the switch and the pump came on. Sounds a bit weak, but it...
-
cattlerepairman reacted to LuckyWolf's post in the thread First show with my Deuce - Poppy with
Like.
Hi All, Finally got my Deuce, Poppy, to her first motor show here in the UK 🇬🇧 Won best in class on the first day! we were swamped all... -
cattlerepairman replied to the thread Wheel bearing getting hot.Aftermarket (New Star) wheel seals can cause the hub to run hotter. Before ripping it apart again, back off the nut another quarter...
-
cattlerepairman replied to the thread M1087 Conversion.You are gaining a ton of extra room there up front. Is that a stock tandem axle chassis or lengthened? Sent from my SM-G991W using Tapatalk
-
I was building it in my driveway, but ran out of time with all of my other life obligations. I took my truck to CO to a guy who has...
-
cattlerepairman replied to the thread Electrical Overheating M35A2.I agree with your thinking. Starter solenoid sticking or starter sticking on are my top contenders. The good news, your Deuce is now a...
-
cattlerepairman replied to the thread Accidentally bought a deuce.Whenever you buy a truck that you can flip for scrap for more money than you paid, it is automatically a win! And, from the pictures...
-
A few good taps with a pin and it's tight as new. Thanks for the advice.
-
cattlerepairman replied to the thread Fuel pump issues.Can you hit the rivet with a punch to seat it better? I don't think it should spin. That would allow the fuse to dislodge or fall out.
-
If anyone is looking for a nice comfy seat that’ll fit these trucks, this is the one I bought off vevor.com. It’s a forklift seat, but...
-
cattlerepairman replied to the thread LDT 465 timing.I see that you have no bites. Heave you seen this: https://www.steelsoldiers.com/threads/m35a2-465-psb6a-injection-pump-timing.162268/
-
I got around to measuring the washers and the hole diameter is around .840” and the OD of the washers are around .750” Would it be worth...