-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
ckouba's latest activity
-
ckouba replied to the thread M1088 camper conversion.With our upcoming trip, it was about time to get out for a shakedown. In stereotypically miserable PNW weather, we went out into the... -
ckouba replied to the thread Post Eco-Hub Speedometer Adjust.Each dip switch should have a number over it, and the ones marked 1, 2, 3, & 10 should be set to off. I can't confirm that as I don't...
-
ckouba replied to the thread M1088 camper conversion.It may need a flange and gasket to seal up the gap, but I am willing to try without it for now and calling it "finished" (finally!)...
-
ckouba replied to the thread Just won an auction - M1088A1.Yes, ^ this!!!! Makes it a LOT easier to line stuff up to get a wheel back on.
-
ckouba replied to the thread What Did You Do With Your Aux Cooling System.Mounted my 1088 vertical trans cooler between the frame rails. Pic in my build thread, was super simple and only required new hoses. I...
-
ckouba replied to the thread M1088 camper conversion.And now a pic for today's progress: Now it's really time to make a door!
-
ckouba replied to the thread M1088 camper conversion.No pics, but a HUGE day yesterday... While working on the roof rack, I noticed my voltage only going down despite having the motor...
-
ckouba replied to the thread M1088 camper conversion.Sounds viable... Weld some platforms on it for mounting them and call it good. Super easy: Find and mount compatible pump (check...
-
ckouba replied to the thread M1088 camper conversion.I forget the actual dia of the intake piping upstream of the turbo inlet, but i'd assume you can just match that and be good. The two...
-
-
My pass though is 20"wide, 30"tall. I'm 6'4" 200 lbs and can crawl through comfortably. I size it so I could crawl on my hands knees...
-
ckouba replied to the thread M1088 camper conversion.I do wish I double stacked the filters as well. I would aim to put them all on one side with the expansion tank and dipsticks/fill...
-
ckouba replied to the thread M1088 camper conversion.In a word, small. I kept it constrained to that size due to the roof sheet metal seam and not wanting to cut into that panel. It's...
-
ckouba replied to the thread M1088 camper conversion.Largely the same view/photo but now the throne has been fully installed and the drain and sump are fully functional (powered and...
-
ckouba replied to the thread M1088 camper conversion.It was a big day today. So much effort behind a very boring photo... Just need to install the mixer and showerhead, hook up the...
-
ckouba replied to the thread Using upper stock frame rails for subframe.A couple of points from my experience: I pinned the habitat at the front and not the rear. Doesn't seem to make that big of a deal in...
