Recent content by Daybreak

Howdy, And you can make something from here. 24v charging thru slave port | SteelSoldiers

Howdy, Need a radiator cap? Here is a quick link member @DieselAddict write up MEP1030 Radiator Cap cross Ref

I would then think she will take all the profits. :oops:

Test it out. Start the unit Have the AUX selected siphon fuel out of the day tank Watch inside the tank, and fuel level Listen to when the AUX kicks on Stop the siphon Watch the day tank fill Watch your fuel level move up Listen to when the AUX pump turns off On all machines it will be a...

@Papi Chulo Start in this thread. MEP-802A MEP-803A Filters and Parts | SteelSoldiers 2nd post has quick links to important stuff. 3rd post has links to all the TM's you need. Welcome.

In a more layman's terms. It is meant for keeping 100% uptime of power. #1 generator is running, and it needs to be serviced. #2 generator is fired up, use the box to sync, transfer, shut down #1 generator and service.

@ribs1 Before you end up with 50 gallons of diesel on the floor...... Set scene In the front of the unit, right next to the fuel fill, behind the panel is where the AUX fuel pump sits. OK, good, you now know where it is. Inside the fuel tank, you have another metering float system. (The main...

Start in this thread. MEP-802A MEP-803A Filters and Parts | SteelSoldiers 2nd post has quick links to important stuff. 3rd post has links to all the TM's you need. Welcome.

I expect it to be forfeited, and re-listed. But, you never know. Maybe a wind farm needs some diesel power to charge the battery banks. 😵

OK, We have a new Winner in California. 2016 Cummins Power Generation MEP-1041 10kW Generator Set MEP-1041 10KW 400Mhz Generator on Trailer. Sold 1/18/2023 Selling for $7,600 before Fees, Taxes, and shipping to California.

Start in this thread. MEP-802A MEP-803A Filters and Parts | SteelSoldiers 2nd post has quick links to stuff 3rd post has links to the manuals

Not all bulkhead fittings are the same. A proper A3816 nitrile well-nut works fine. Don't over tighten and split it. The correct 1/4" Brass Bulkhead Fitting (Includes Viton O-Ring) works fine. There are many options out there. The 2 items work. If you use something else, and have problems. That...

Power the generator up. You are running it to low a RPM You want the 120/240 running at 60Hz >speed it up< Yes, the 2 cylinder will be even worse at a slower idle. Note: Don't do any fancy youtube processing. Just straight upload. Don't shoot video in portrait mode. Here is one of my MEP-802A...

Here is a member which put up a bunch of video's off grid with his MEP-802A. Noble Country - YouTube

Remove it, and set it on the ground. I had a MEP-802A sitting on a pallet in the back of a truck after coming home with it. It bounced and rattled the lifting eyes. Sounded like someone ringing bells. Set it on the ground, problem solved.