-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
deank's latest activity
-
deank replied to the thread Switch not working .Malfunction numbers 5, 42, 33, 34 in that order should locate your issue. I am signing off for tonight. -
deank replied to the thread Switch not working .Start on page 2-59 and look for the symptoms you have.
-
deank replied to the thread Switch not working .If you did not already know, this the link to all of the manuals. TM 9-2320-289-20 is the troubleshooting manual...
-
deank replied to the thread Switch not working .Here is a good place to start looking for solutions. https://steelsoldiers.com/threads/cucv-helpful-threads.123199/
-
deank replied to the thread Switch not working .
-
-
deank replied to the thread Switch not working .You may want to start by taking a look at each fuse. Pull them out one at a time and look for any that are melted.
-
deank replied to the thread Switch not working .I suspect issues with fuses or fusible links. The ignition switch is down towards the break pedal but mounted to the top of the...
-
Y'all are seriously overthinking this. I'd have cracked my cap in half putting a blind rivet in it and replaced the whole assembly with...
-
deank replied to the thread Switch not working .Did you change the switch or the lock cylinder? The switch is on top of the steering column under the dashboard. The lock cylinder is...
-
deank replied to the thread What have you done to your CUCV today/lately - Part 2.Recently managed to fire up and run the m1031 genset last week after getting the new control unit programmed. Adding circuitry tomorrow...
-
deank replied to the thread Help with mystery wire identification.Seems I was wrong. I followed the links above and saw a better picture of the printed citcuit. That third pin goes to the Gen 2 light...
-
deank replied to the thread Help with mystery wire identification.Hey again. Looking at the picture you sent of the printed circuit, it looks like that circuit is either for the seatbelt indicator bulb...
-
deank replied to the thread Help with mystery wire identification.Very happy to about your success! Are you able to trace what the circuit with the broken tab goes to?
-
deank replied to the thread Help with mystery wire identification.What about the rear with the cluster out?
-
deank replied to the thread Help with mystery wire identification.Ok. For the sake of checking everything, please try the turn signals and marker lights with the cluster unplugged. They may not function...
