Recent content by Finallygotone

simp5782, I do have it chambered, lines discontented will try to unscrew it, thanks, Joe

simp5782, I have done that to get it home and tied the lines, I got rear ended by a car, it must be change its broke, was asking if it unscrews for that pipe nipple or do I have to change the hole thing, thanks, Joe

porkysplace, yes I could have but he approached me with a shitty attitude, same Parish where an off duty cop told me if you come into our parish we will arrest you, book you, lock you up and tow the truck in, I just simple asked when do you go back on duty and tell me where you want to meet...

I am going to have to change one brake chamber on the read of the 5 ton, does it unthread at the bucket or would it be best to change the bucket and the pipe nipple that goes to the well hub.

we still are free here in Louisiana, got stopped by a cop the other day, he says you don't have a plate, said sure don't and don't need one, his reply how do you know that, I said cause I do, you need to learn the law before you pull me over again, he turned around and got in his car and left...

the worse we had it here is SW Louisiana was two weeks with out power, 100 degrees with 100% humidity and to make it worse than that the local EMT's Voluntary fire department got the MRE's and would make the people drive there three times a day to get a meal, one told me he did this so when the...

I bought my Onan 37.5 KW off ebay, the fellow raved how great and he would deliver for that price, 1,800 dollars so I told him if it did not look as the said and ran so he would be leaving with it, it was all that he said it was, runs the complete house, all electric, go it 150' away from the...

nice looking truck, man that is a load of logs, fine looking lumber that will be.

up date, the converter must have been defective, so I decided to hook up the light direct to the batteries and it worked left them on a while and they have survived, course when I leave to cut them off, still might get that converter that Semp5782, the one I got was half that cost from Amazon...

the light were just to go under the dash facing the floor just to give a little light at the feet area, for me and passenger, I got them off Amazon with the converter, I tapped into a 24 volt, took the 12 that came off and there was two grounds, well bolted it to the lower dash, put a 12V...

where do if find that 12 volt wire or wires, mine has 4, 6 volt batteries, making it 24 volt thanks, Joe

Hey you all, I have some LED light that are 12 volt, is there any place that I can tie into to use only 12 volt instead of 24V, thanks ahead of time, Joe

Welcome, your going to love it here these guys are great they will answer the most simple sometimes stupid question that one can ask and never put you down, they are the Well Spring of Wisdom.

guess I did not get that right but any way its on Amazon

gosh still have my tractor with homemade from attachment, drop one of them sure going to need help, that last front axel bearing and seal change out was enough just lifting the brake drum twice, do have me a Clark 500 fork lift now, just in time, to break the beads I got a slide bead breaker...