Recent content by FirstGen FBody

i have to change the fuel filters so ill do that and bleed it really good. thanks

i put in 5 gallons and it fired right up after cranking it a few times. It ran fine when i went to get fuel and then for 20 miles after that. Should i still bleed it? What is balancing the fuel feed? iv been good for 2 years with filling up once a month and not having an issue but i should...

ran out of fuel and had to have the old lady bring me some fuel lol.

rockers $10 on flea pay

if #15 was meant for me i figured it was a bent push rod since i listened to it with a pry bar narrowed it down to the passenger side head, cracked injectors no change and swapped injectors no change. i didnt feel like pulling it apart since it runs fine and i was planning on swapping it out...

thanks for posting. That sounds like the noise mine makes, iv been bad and just kept on driving it lol. i put almost 4k on it like that iv spent more then i payed for it so far thats what i did, 6.5t here we come

what do the different frag levels consist of? iv seen panels made of aluminum and steel. do the lower level kits use aluminum then they use the steel on higher level kits? thanks

does anyone know the correct location for these reverse light brackets? the parts tm shows them on the corners but i have seen them mounted under the tail light im assuming the tm is the correct location thanks

Do these work with M4 style rifles? Can they be flipped upside down? They look like they are the same height as the old style ones that my truck has. The prop guns i have are too short, 16 inch barrel and stock fully extended. The stocks sit on not in the floor brackets and the barrel clamp...

I found the wiring diagram for the turbo so ill probably make a harness. I was looking at TCMs in the TM and there are different options for chips. I think 4 but i dont have the TM up right now. Dose any one know what the difference is/which ones are better? I'm assuming that the differences...

get that 4/s outta there! lol. I was going to use the factory "folding" rear seats but ended up finding a set of folding mastercraft seats for cheap. still need to get seats for the front.

lol, i hear ya. I like that DIY harness idea. what should i search, i tried a few different things with no luck. I have a engine trans and t case it was one of those just cut the frame rails deals, but it didnt come with the harness. Is there a TM for wiring schematics and connector pin outs? id...

Im gathering parts to swap from a 6.2 3l80 60 amp alt to a 6.5T 4L80E 200amp alt and was wondering what body harness and engine harness ill need to get. Im probably going to eventually put in reverse lights, AC with the rear wheel well condensers and an ECV front end. Im assuming ill need 1151...

Im not worried about it being 100% original/military. Im only looking for 95%, lol. If i do go with an aftermarket seat it will have to look like it belongs in a military vehicle. Im not a huge fan of the leather seats in hmmwvs, im sure they are comfortable but they look odd. im not looking for...

Im looking to get new seats. I have the original foam pads now. How comfortable are the high back seats? Would i be better off getting a off road racing seat? thanks