Recent content by ghog50cal

I have tried a bunch of them and they don’t seam too work out some hold for a couple of uses then it falls out or there too big or small

I got an assorted pack of push nuts and none of them seam too work I’ve tried all kinds of stuff and still can’t get anything too hold them in

Thank you for all your help

So the thermal switch has power when I jump the thermal switch the truck starts right up there’s jumper wires everywhere lol I removed the jumper wires from the switch in the cab and hooked it back up too the button with the thermal switch jumped it starts right up the only thing is I never...

It’s plugged in too the front of the starter

So I wired the push button open and am getting 24 too the top and bottom of the aux relay on the frame when it’s off there’s no voltage too the top or bottom

yes that’s with the relay In place 87 too ground is OL

I have load tested the batteries and there on the charger now so I don’t drain them as I’m working on it I looked at the lpbd again last night and it looks clean with no issues checked too see everything was tight back there also

yes I meant k1 sorry so pin 30 is constant at 23v Pin 86 has 23v constant Pin 85 has 23v constant and when I press the start button pin 87 gets 23v

Now when I press the start button I’m getting a click in k1 now but the starter is not activating

I don’t know what I did but I now have power at k1-86 still no start from the switch

i have power getting through cb21 i have not gotten power over at the frequency box yet I’ve checked my meters against each other and there working correctly on a constant

well everything is checking out good on it but still no starter button function

I don’t think px33-f1 has any power

I’m not sure which ones px33-f1