-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Guyfang's latest activity
-
Now I'd try a continuity test from VR 5 and 6 to F+ and F- on the exciter board ( item #10 ) as Kurt indicates in his chart above. If... -
It would ready help if you performed the AC Voltage Regulator test per the TM. It has the expected readings for each test. The 17.4vdc...
-
Wow wheeeeeeeeeeeee it WAS the relay! 5 new 24v Bosch relays were secured to attempt to rectify the no-start condition because why...
-
For future reference you can go to the top of the forum page. You will see a bar with "Rules" "TM" and "Vendor Spotlight" listed...
-
Section 2-27 on pages 95/96
-
The VR test procedure is in the generators -24 TM
-
If the Fuse Mod fuse is good and you don't have power the the outlet then you need to perform the AC Voltage Regulator test. Post up...
-
Take the fuse out of the holder and test it. it is a slow blow fuse, but there is no such thing as a time delay reset fuse. Remove it...
-
If you can't get the gasket in time, you can also purchase a 12"x12" square of gasket material from your local auto parts store and cut...
-
Guyfang reacted to Chainbreaker's post in the thread MEP-002a possible Injector Pump Issues with
Like.
Just a note of caution regarding upcoming summer operation... since the -002a/-003a are "air cooled" diesel engines, I personally would... -
Guyfang reacted to peapvp's post in the thread Converting a 005A with a Digital Controller with Like.
A few after thoughts on this project. Normally we use only Made in USA products for obvious reasons. This was our first time branching...
-
Guyfang replied to the thread Gamagoat manuals.Goat Motor TM
-
YUP, just be careful, the center of the filter is usually the downstream / output side, so anything you pour in will go unfiltered into...
-
Before pulling the injector, take 2 minutes and load it until it bogs, the push up on the linkage and see if engine revs up or not. That...