Recent content by helm1008

Hello did you use copper spray on the new style head gasket? I've always love that stuff but was unsure weather to use it, looks like the new gasket already has sealer for water ports.

Hello all im no stranger to work so this head gasket change will not be problem, I'm just over calculated in what i do always. im a carpenter up hear in northern maine and ive done more then most to get where i am today at 32yrs. I do finish work and build camps out on islands up on northern...

Yes going to do freeze plugs ss, repaint few things, clean all threads, re surface head I've read a lot but i want to get everything figured out before hand its January in maine and I'm doing this job in tarp tent outside minimal heat. I'm to busy in summer for this job so it now or never.

WillWagner That is the kit i have now. I just dont know what gaskets go to what model number on the picture i posted.

Hello can anyone point me in the right direction to crossrefrance gasket part numbers ? I'm getting ready to change head gasket, I'm trying to get all my gaskets and parts ready and in order before i start job.

IN

Hello I just installed this kit thought I would give you guys my two cents. weld back hinges on keep the bed on truck lift and block bed up, install the lift bolt in lower pins lower bed down, adjust the lift where you want it up and down left to right and drill for top pins weld everything in...

I never balanced my 37s never had problem, on that Same note I dont go much above 55mph. I used craiger steel wheels.

Wow that is good deal I was looking around but didnt see anything that reasonable. Thanks!

Ya not worried about any of that stuff I can fabricate. My biggest challenge is finding pto unit for transmition.

See I thought it looked reversable but I wasnt sure. I guess I'll give that a shot thanks, so if that works out I'll need drive shaft and pto Assembly for transmition. If anyone Has such parts there willing to sell I would be interested thanks.

What I was thinking is running off regular pto to front then have the winch run on chain and sprocket, because its opposite side if its 30:1 ratio cant be to much pressure on the pto drive line ?

The winch is on front

Can I pick away at this subject little more gentlemen? I just bought a m35 already mounted with 5ton winch that's not hooked up to pto power , any ideas ? For me the trucks not Novelty it's going to be a work truck

Sorry for the this bomb post, can any of you Gentleman Point me in the correct direction of a complete system charging check list. My Gen 1 light stays on while my Gen 2 light never turns on. With a full charge the battery will last about a week. ?