-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
hike's latest activity
-
Pacmaning means it has one light on that is racing back and forth across the panel continuosly.. Plug in P301 has been replaced.. pins... -
hike replied to the thread Power Distribution Panel M1083A1 10/98.Not sure what "Dash indicator is Pacmaning" means X3 feeds CB77 to P301-14 to wire 1546 brings power to the gauges. Check the pins in...
-
Still alive and still out on the road, but that's winding down now... I can't get my cell phone to work in my basement, but here in the...
-
Hey all, i’ve been wanting to do this project for quite a while… Essentially, I bought a M1088A0about a year and a half ago and have...
-
Are the surfaces flat? I use a flat file to draw file mating surfaces flat(pull file perpendicular to the long axis of the file like a...
-
hike reacted to wandering neurons's post in the thread Manual CTIS, electric over pneumatic. with
Like.
After fighting the CTIS for several years, I finally broke down and made my inflation system electric-over-pneumatic. Before the mod, I... -
I had the EUC in less than two weeks. I has some repairs done at Steve’s Auto Service including installation of new driveshafts...
-
One is in the front of the transmission case, down on the passenger side(input speed code 2214)), the Turbine sensor code 2215 is in the...
-
Thanks for taking the time to write that out. Send me your Venmo and I’ll buy you a six pack 😎. I’ll run those wires down and check the...
-
I suspect you meant to type 2215 instead of 2255(there is no 2255 code)? all the 54 series codes are ratio failures. If the 22 code...
-
hike replied to the thread M1088 transmission trouble.This looks like a good Allison code manual. Code list begins on page 25. Found on this webpage. Good luck—
-
Always learn something during mock up. Need clearance for the housing clips. I've seen some examples of trucks with dual intakes...
-
I'm not affixing to the cab... mine will be attached to the forward most cross member. Bracket is mostly made.. just need to test fit...
-
hike replied to the thread Little Bear Build.Check out Western Ranger on Youtube. He is @Gunny 0369 here: Beautiful, creative, capable rigs with slide outs—
-
If you're doing any serious offroading, you're either going to want to draw an imaginary 45* from your rear tire to about halfway up...