Recent content by JHutch

By the way 85/140w gearlube doing Much better by not leaking outta the Pitman Arm. Only few drips nothing like how 90w leaked out Thanks JHutch

I ordered new retract springs for the brake and clutch. Checked out the Manual for the proper procedure. Got it and it’s pretty straightforward without looking at Manual. Thanks JHutch

If anyone has any Helpful hits , My ears wide open. Thanks JHutch

I will be doing the Master Cylinder Myself. Just got under there and sprayed PB on fittings and bolts and nuts. I can reach everything so I can do it just gotta take My Time. Adding the fluid line from Master to Air assist pod also. Will bleed from fitting on air assist pod underneath . Will be...

Just went out to check the wheel wells to see any brake fluid :::; No Fluid so far and I parked Betsy 5-6 hours ago. Yes 👍🏼 Also good to know the license plate is still there held by wire. Gonna drill holes at rear and tap for screws Thanks JHutch

Hey Guys Update :: the right front with the real bad seal is changed. New wheel cylinder 👍🏼 Tomorrow another mechanic gonna check out the Master. The other 5 wheel cylinders will be done soon by the Guy who did the one today. Got Betsy up to 52 mph in 5th gear on the way to the shop this...

Gonna have the truck guy who’s gonna fix the brakes look at the suspension. Thanks.

Right side

Was just under rear end. The torsion bar connection points look flush with ends and lined up. Didn’t see damage to bushings at ends of torsion bars. At the center of the wheel suspension the large C-clamp area could look better.

Thank You. I will check into the suspension on My Deuce. 👍🏼

Thanks. I will check into the rear suspension. 👍🏼

During run time. Dash Gauges Air stays round the 90 psi line after charge up. ::::; Overpressure Safety Valve :: is that the same as Air System Safety Valve - if so then I found it in manual for the M35A2. I will look into maintenance for it. Do You Guys have any suggestions on how to deal...

Brake Master Cylinder came today 👍🏼 Only waiting for Line from Master to Air Assist Pod. And then fall. 👌🏼👌🏼👌🏼 Thanks

I think the Air pressure gets round 90-95 when charged. I think. I will get back to you about it in 2 days after She Runs. 👍🏼 Thanks

Thanks :: I sprayed the pectcocks with PBBlaster. Haven’t tried to loosen them yet. Gonna spray again. Do not hear any air leak as yet. I run Her for 40 minutes every 10-12 days. I ease Her out trying not to step on brake. I use parking brake to stop. But Air pressure always at zero after...