-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Recent content by JoeD
-
J
Deuce brake adjustment TM
I know this is an old link but thanks to TommyG45 from Hinckley Ohio! -
J
leaking rear axle seal
Sounds like good advice. Since the CTIS is already disconnected i though i would get the Bearing conversion from Memphis Equipment. The TM for the A3 bearing/seal replacement seems a little light. Would i use the TM for the A2? seems more detailed -
J
leaking rear axle seal
I just noticed the rear axle is leaking on my bobbed M35A3. I only drive my deuce less than 200 miles a year. Can I get by with just letting it leak or is it imperative I replace the bearing/seal? I know the part is not inexpensive and funds are limited in retirement. if I have to replace... -
J
Allison Trans service
Hi Guys, I have had my M35A3 for over a year now. With my work schedule I can't seem to find the time to change the MO in the Allison trans to ATF. I'm in the north end of Medina County, Ohio(Hinckley) Can anyone recommend a shop that will do the change for me? thanks! -
J
Parking th M35A3
makes sense kblazer87. I incorrectly assumed keeping it in gear would hold it. thanks! -
J
Parking th M35A3
When I am out with my A3 and park it, I of course, use the parking brake and chocks. I leave it in Neutral. sometimes it a pain if I am just running up to Home depot etc to use the chocks. As long as it is on level ground would it be ok to just use the brake and put the truck in a gear instead... -
J
New member from Ohio
Welcome from Medina County, Ohio- JoeD
- Post #15
- Forum: Requirements For New Members
-
J
Ohio Newbie
I am a newbie. My vehicle is a bobbed M35A3. (I had some posts about some tire disasters when I had it shipped) wondering who is in Northeast Ohio ( I am in Hinckley) with an MV and if you frequent any shows/meets etc. in the area. -
J
M35A3 tire repair Assistance Question
Hi All, well I got my A3 back from C & C equipment. They replaced the tires that were ruined from the trucking company that deflated them to transport it. I also had him replace the rims along with the new tires. He replaced the soft top with a new hard top and changed the front hubs. He painted... -
J
M35A3 height question
Hi guys, I want to get my M35A3 in my garage this winter and it will fit if it was not for the height of the exhaust stack. Would cutting it shorter so it will be 2 " above cab harm anything? or should I just remove it at the joint when I want to pull it in the garage (seems like a pain...