• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Recent content by JRMMD

  1. J

    Help for a new m936 owner please...

    Sorry I didn’t phrase the question correctly. I bought the two solenoids and have them. You mentioned to Goliath to buy additional parts to replace (I assume) what the circuit board is doing. Some diodes and a jumper feed. Those were the items I meant to see if you had recommendations and where...
  2. J

    Help for a new m936 owner please...

    Hey Simp and all. So I pulled my PCB and have the exact same situation as Goliath. Box is the same. Wire colors are the same (confirm with my pic). I read the rest of the thread. Assume my solution would be the same (my ‘84 has ABS too). I need to order parts via Amazon too. Didn’t know if you...
  3. J

    Help for a new m936 owner please...

    Really appreciate the initial help on the PCB! I smacked the snot out of it and it, in fact, restored power to the ignition switch. So, at a minimum, the engine is trying to turn over again. I didn't see the post about the fuel bypass screw until after I was no longer at the truck. So, I will...
  4. J

    Help for a new m936 owner please...

    I can't deny I may have made this mistake. For what it's worth, it died on the exit before I would have had the chance to do that - because they had it started when I got there to pick it up. But I certainly could have screwed it up thereafter. In desperation to get it started, I was probably...
  5. J

    Help for a new m936 owner please...

    I will happily go after it with a hammer. Definitely anxious to learn more about the truck and put it to work. I will definitely research the PCB and learn more about it. Thanks! The truck/farm is in Lawrence County and I work out of Nashville - so basically up and down the central part of the...
  6. J

    Help for a new m936 owner please...

    Ran fine on interstate. I exited and it died on the ramp. Tried to restart and it turned over fine but wouldn’t fire. Let it sit for a bit and tried to start but then it wouldn’t even power the dash or started (symptoms stated above). Let sit longer, it turned over and started. Drove another...
  7. J

    Help for a new m936 owner please...

    Thank you for a quick reply. I searched the site before posting but didn’t see this.
  8. J

    Help for a new m936 owner please...

    Hello all. I am a very new m936 owner (as in yesterday). Bought a 1984 wrecker and drove it about 80 miles before it decided to die on the road. A very expensive tow last night and it is at least at the farm where I can slowly investigate and become much more familiar with this newest toy. I'm...
Top